MOTOR GP-WINDOW WIPER 4963367 - Caterpillar

Discharge air is hot and could cause property damage and/or personal injury.
Note: Do not operate the unit below any overhang.The unit should have adequate clearance on all sides to allow proper air flow. Allow approximately 2 m (6.6 ft) of clearance on all sides.
Place the unit in a stable position.
Ensure that the enclosure doors are closed and locked during generator set operation. Access to the generator set is prohibited during operation of the generator set. Access to the emergency stop push button cannot be obstructed or restricted. The emergency stop push button must be easily seen and the emergency stop push button must be readily accessible. The door latch cannot be lockable. The door latch cannot contain a provision for making the door latch lockable.
Failure to close doors when the unit is operating can result in doors opening and closing at a high rate of speed. Contact with the doors may cause personal injury or death.
Distribution Panel
The control panel and power distribution area is illustrated in image 1
Illustration 1 g06057225
View of Control and Distribution Panel (enclosure door and breaker door with bus bar viewing window not shown)
(1) Steel enclosure with hinged, lockable door (not shown)
(2) EMCP 4
(3) Emergency Stop button
(4) Alarm
(5) Service tool connector
(6) Manual holder
(7) Main earth terminal
(8) Micro safety switch for bus bar door
(9) Main bus connection (bus bars with M12 studs)
(10) Circuit breaker, 4-pole molded caseM12 lugged cable fasteners should be torqued to 100 20 Nm for more information, refer to 1E0279.
DANGER: Shock/Electrocution Hazard-Do not operate this equipment or work on this equipment unless you have read and understand the instructions and warnings in the Operation and Maintenance Manual. Failure to follow the instructions or heed the warnings will result in serious injury or death.
Standard Lugged Connection
When connection to the customer bus bar system using a standard lugged connection, insulate the bare end of the lug with tape. Insulating the tape will eliminate as much exposed live surface as possible.Load Connections
DANGER: Shock/Electrocution Hazard-Do not operate this equipment or work on this equipment unless you have read and understand the instructions and warnings in the Operation and Maintenance Manual. Failure to follow the instructions or heed the warnings will result in serious injury or death.
Verify the correct load phase rotation with the generator prior to connecting the output power cables.
Ensure that the generator set is not operating. Place main circuit breakers in the "OFF" position. The "OFF" position is the open position.
Connect the output power cables to the bus bars.
Failure to connect the unit to a suitable grounding electrode can result in electrical shock and may cause injury or death.
Connect the ground connection to a suitable grounding electrode of no more than 25 ohms.
Connect the control wiring (if equipped) for the automatic start/stop to the connection points for the remote start/stop.
Close circuit breakers after the connection is made and the engine is running.Installation Location
Rental Generator Set Operation Site
The rental generator set must be parked on a flat surface. A rental generator set can be parked on a