MOTOR GP-GEAR 4T6066 - Caterpillar

Illustration 71 g01227761
Install guard (J) over the tooling. Fasten the buckles. Tighten the straps.
To prevent possible damage to your hearing, always wear ear protection when using this tool and/or working around noise generating tools.To avoid eye injury, always wear protective glasses or face shield. Make sure no one can be injured by flying objects or debris when using tools or working on a component.
To prevent personal injury or even death from ejected parts or flying objects never remove the upper rigid guard or the lower flexible guard during operation of the portable track press. Never remove either guard when the tool is under pressure.
Turn on the hydraulic pump. The track link will be pulled onto the ends of the cartridge pins. Watch carefully to ensure that the track link is pulled evenly. When the track link is in place, plate (A) will contact the ends of the cartridge pins. The gauge on the pump will indicate a sharp rise in pressure.
The track link must be pulled evenly onto the ends of the cartridge pins. Turn off the pump if one end of the track link is offset more than 6.0 mm (0.24 inch) from the other end of the track link.
If one side of the track link has been installed farther, release the hydraulic pressure from the hydraulic cylinder. Move the hydraulic cylinder to the side of the track link that is trailing behind. Do not move the centerline of the hydraulic cylinder to the outside of the threaded rods. If the centerline of the hydraulic cylinder is outside the threaded rods, the tooling may become damaged. Once the track link is even, center the hydraulic cylinder to the track link. Continue to install the track link.Note: 265-8034 Hydraulic Cylinder and 265-8035 Hydraulic Cylinder have a 12.7 mm (0.50 inch) stroke. It will be necessary to stroke the hydraulic cylinder several times during the removal process. 360-6967 Hydraulic Cylinder has a 60.5 mm (2.381 inch) stroke. This hydraulic cylinder may complete the removal process with a single stroke.
Illustration 72 g01437029
Once track link (AA) is installed, remove the hydraulic cylinder. Loosen nuts (C).
Apply 222-3114 Anti-Seize Compound to the bore of track link (BB) and the cartridge pins.
Install track link (BB) between plate (A) and the cartridge pins. Tighten nuts (C) to locate track link (BB) onto the ends of the cartridge pins.
Repeat Step 18 and Step 19 to install the other track link.
Illustration 73 g01227764
If necessary, remove the track bolts. Plates (N) can be slid inward on the threaded rods to verify that both track links have been installed. There should be a gap of approximately 1.5 mm (0.06 inch) between the outside track link and the inside track links.
Illustration 74 g01227765
After the track links have been installed, all the tooling can be lifted with a hoist from the tapped holes that are provided on the tooling. The tapped holes are 3/8-16. If a hoist is not available, each component of the tooling can be disassembled. The heaviest components are plates (A). One