MOTOR GP-TRAVEL 5095931 - Caterpillar

Hydraulic System Oil Level - Check
Kingpin Bearings - Lubricate
Ripper Cylinder Bearings - Lubricate
Secondary Steering - Test
Steering Cylinder Ends and Tie Rods - Lubricate
Tandem Drive Oil Level - Check
Tire Inflation - Check
Wheel Lean Bar Bearings - Lubricate
Wheel Lean Bearings - Lubricate
Wheel Lean Cylinder Bearings - Lubricate
Initial 250 Service Hours
Transmission and Differential Oil Filter and Screens - Replace/Clean
Initial 250 Service Hours (or at first oil change)
Engine Valve Lash - Check
Every 250 Service Hours
Cooling System Coolant Sample (Level 1) - Obtain
Initial 500 Service Hours (or at first oil change)
Battery or Battery Cable - Inspect/Replace
Electronic Unit Injector - Inspect/Adjust
Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)
Cooling System Coolant Sample (Level 2) - Obtain
Every 500 Service Hours or 3 Months
Braking System - Test
Differential Oil Filter - Replace
Differential Oil Level - Check
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Engine Shutdown Switch - Check
Fuel System - Prime
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Fuel Tank Cap and Strainer - Clean
Hydraulic System Oil Sample - Obtain
Oil Filter (Hydraulic Return) - Replace
Oil Filter (Hydraulic Tank Return) - Replace
Oil Filter (Pilot) - Replace
Tandem Breather - Clean/Replace
Tandem Drive Oil Sample - Obtain
Transmission and Differential Oil Filter and Screens - Replace/Clean
Transmission and Differential Oil Sample - Obtain
Wheel Bearing Oil Level (Front) - Check
Wheel Bearing Oil Sample (Front) - Obtain
Every 1000 Service Hours or 6 Months
Blade Cushion Accumulator - Check
Rollover Protective Structure (ROPS) - Inspect
Transmission and Differential Oil - Change
Every 2000 Service Hours or 1 Year
Differential Thrust Pin Clearance - Check
Engine Valve Lash - Check
Hydraulic System Oil - Change
Every 2000 Service Hours or 2 Years
Battery or Battery Cable - Inspect/Replace
Circle Drive Oil - Change
Cooling System Pressure Cap - Clean/Replace
Crankshaft Vibration Damper - Inspect
Electronic Unit Injector - Inspect/Adjust
Engine Valve Rotators - Inspect
Evaporator Coil and Heater Coil - Clean
Tandem Drive Oil - Change
Wheel Bearing Oil (Front) - Change
Every Year
Cooling System Coolant Sample (Level 2) - Obtain
Engine Air Filter Primary Element - Clean/Replace
Every 3 Years
Seat Belt - Replace
Every 4000 Service Hours
Control Manifold (Steering Backup) - Clean/Inspect/Replace
Every 4000 Service Hours or 2 Years
Hydraulic System Oil - Change
Every 6000 Service Hours or 3 Years
Cooling System Coolant Extender (ELC) - Add
Every 12 000 Service Hours or 6 Years
Cooling System Coolant (ELC) - Change