MOTOR GP-WINDOW WIPER 5110819 - Caterpillar

Remove the hose assembly (6) and the two connectors (7). Discard these parts.
Illustration 4 g01043882
(5) HEUI pump (6) Flexible oil line (7) Connector (8) Injection actuation pressure control valveInstallation of the 240-0717 Engine Oil Lines Gp
Illustration 5 g01043862
(5) HEUI pump (8) Injection actuation pressure control valve (9) Connector (10) Clip (11) Washer (12) Bolt (13) Spacer (14) Tube assembly (15) O-ring (16) O-ring (17) ElbowNote: Some engines may not have a fuel filter mounting bracket. The existence of the fuel filter mounting bracket on the air inlet cover helps to determine the proper spacer to use. If the fuel filter bracket is mounted on the air inlet cover then the 135-5096 Spacer must be used. If the fuel filter bracket is not mounted on the air inlet cover then the 122-5855 Spacer must be used.Note: In order to determine the correct spacer for installation, refer to the original assembly. Refer to illustration 1 and illustration 2. Refer to illustration 6 and illustration 7 for the correct installation of the spacer and clip.
Illustration 6 g01043888
Correct installation of 122-5855 Spacer with no fuel filter mounting bracket (10) Clip (11) Washer (12) Bolt (13) Spacer (14) Tube assembly
Illustration 7 g01045006
Correct installation of 135-5096 Spacer with the fuel filter mounting bracket (10) Clip (11) Washer (12) Bolt (13) Spacer (14) Tube assembly
Illustration 8 g01043711
(8) Injection actuation pressure control valve (9) Connector (15) O-ring (16) O-ring (17) Elbow
Apply a light coat of oil to the O-rings (15) and (16) during installation. Install the O-ring (15) on the connector (9). Install the O-ring (16) on the connector (9). Thread the connector (9) into the port on the cylinder head by hand. Tighten to 48 + 5 N m (35 + 4 lb ft).
Apply a light coat of oil to the O-rings (15) and (16) during installation. Install the O-ring (15) on the elbow (17). Install the O-ring (16) on the elbow (17).
Back off the jam nut on the elbow (17) to the top of the threads on the elbow assembly (17). Push the washer tightly against the jam nut. Check that the washer is as tight as possible. Thread the elbow assembly (17) into the port of the HEUI pump (5). Hand tighten the elbow (17) into the port of the HEUI pump until the washer is tight against the HEUI pump (5). Unscrew the elbow assembly (17) no more than one complete turn to 40 degrees.
Align the tube assembly (14) with the connector (9) and the elbow (17). Loosely thread each end of the tube assembly (14) onto the connector (9) and the elbow (17). Position the elbow (17) in order to not create stress in the tube assembly (14) .
Attach the clip (10) to the tube assembly (14). The flat side of the clip (10) must be toward the air inlet cover. Place the washer (11) onto the bolt (12). Insert the bolt (12) through the clip (10) and the spacer (13) .Note: This kit includes two different spacers. 122-5855 Spacer has