MOTOR AS 5254490 - Caterpillar

Illustration 13 g00784082
Install end cap (17) and eight bolts (16). Tighten bolts (16) to a torque of 78 N m (58 lb ft). Use the tightening sequence in the photo above in order to properly torque bolts (16) .
Illustration 14 g00783407
Torque eight socket head bolts (32) to a torque of 32 N m (24 lb ft).
Install two O-ring seals (33) and (34) .
Illustration 15 g00783405
Install seal (31) in cover (30) .
Illustration 16 g00783404
Install cover (30) and retaining ring (29) .
Illustration 17 g00783397
Install O-ring seal (15) on relief valve (14) .
Illustration 18 g00783398
Install relief valve (14) .
Illustration 19 g00783396
Illustration 20 g00783394
Install relief valve (13), two retainers (12), and two springs (11) .
Install two O-ring seals (10) on two plugs (9) and install the plugs.
Illustration 21 g00783392
Install five O-ring seals (8) and O-ring seal (7) .
Illustration 22 g00783391
Install cover (6) and four bolts (5). Tighten the bolts to a torque of 91 N m (67 lb ft).
Illustration 23 g00783389
Install six backup rings (6) and four O-ring seals (5) on valve (4) .
Illustration 24 g00783387
Install valve (4) .
Illustration 25 g00783386
Install solenoid (3) and nut (2). Tighten the nut to a torque of 8 N m (6 lb ft).
Illustration 26 g00783383
Note: Only the right hand side of the machine has a speed sensor.
Use the following procedure in order to install speed sensor (1) .
Turn in the speed sensor until the speed sensor touches the speed ring. Then back out one full turn.
Back out the speed sensor until the notch is 180° from the motor shaft centerline.
Tighten the locknut to a torque of 13 N m (10 lb ft). Do not allow the speed sensor to turn while the locknut is being torqued.End By: Connect the piston motor (propel) on the final drive planetary. Refer to Disassembly and Assembly, "Rear Drive, Final Drive Planetary, and Piston Motor (Propel) - Connect".