MOTOR AS-FAN 5596622 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 333-0759 Inj. Sleeve Shaft As. - 1/2 Drive 1
B - Loctite 246 1
Thoroughly clean the bore in the cylinder for the electronic unit injector sleeve.
Illustration 1 g02643976
Illustration 2 g01850908
Install new O-ring seals (1) on electronic unit injector sleeve (2). Apply clean engine oil on O-ring seals (1). Apply a light coat of Tooling (B) to area (X) of electronic unit injector sleeve (2). Install electronic unit injector sleeve (2).
Install Tooling (A) into electronic unit injector sleeve (2). Hand tighten electronic unit injector sleeve (2) until electronic unit injector sleeve (2) is seated in the cylinder head. Tighten electronic unit injector sleeve (2) to a torque of 150 10 N m (111 7 lb ft).
Remove Tooling (A) from electronic unit injector sleeve (2). End By:
Install the rocker shaft and pushrods. Refer to Disassembly and Assembly, "Rocker Shaft and Push Rods - Install".
Install the electronic unit injector. Refer to Disassembly and Assembly, "Electronic Unit Injector - Install".