MOTOR GP-PISTON-SLIPPER 5I8729 - Caterpillar

5I8729 MOTOR GP-PISTON-SLIPPER Caterpillar parts 325, 330 L

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA5I8729
5I-8729
5I8729

Caterpillar 5I8729 MOTOR GP-PISTON-SLIPPER

Weight: 132 pounds 59 kg.

Buy MOTOR GP-PISTON-SLIPPER 5I8729 Caterpillar genuine, new aftermarket tractor parts with delivery
EXCAVATOR,

Compatible equipment models: 5I8729:

EXCAVATOR 325 330 L Caterpillar

Number on catalog scheme: 4

Caterpillar 5I8729 Parts scheme MOTOR GP-PISTON-SLIPPER

For full view, you need register

Information:

Installation Procedure
Illustration 1 g00525811
Use nut (12) to install lever (13) on steering gear (6) .Note: There are springs that are enclosed in the transmission position sensor. Do not allow the parts to separate.Note: Route the wire assembly to the original routing.
Illustration 2 g00525782
Use two allen head screws (11) to install transmission position sensor (10) .
Illustration 3 g00525776
Illustration 4 g00525773
Install support assembly (9) on steering gear (6) . Install four allen head screws (8) .
Install steering gear (6) .
Connect wire harness connectors (5) and (7) .
Illustration 5 g00525727
Illustration 6 g00525770
Install handle (3) . Install four bolts (4) underneath handle (3) .
Illustration 7 g00525491
Install wire ties.
Install brake control (2) .
Install three allen head screws (1) .
Recalibrate the lever position of the steering gear.
The detent of the steering lever is adjusted at the factory. This detent occurs just prior to brake engagement while the lever is being pulled. The detent position may require adjustment if the gearbox is replaced.
In order to change the location of the detent, remove the pipe plug on the front of the gearbox. Use an allen wrench to rotate the screw that is located behind the pipe plug.
A PWM sensor is used for steering. The sensor data can be displayed in a percentage of the duty cycle on the main display module of the dash. In order to adjust the location of the detent, the duty cycle value of the sensor must be 25.8 1.0 percent greater than the value when the lever is fully released. If the lever is released and the value is 12 percent, the detent should be between 36.8 percent and 38.8 percent.
Use a 4C-8195 Service Tool in order to obtain the above data. Press the mode switch. Hold the mode switch until "COMPONENT DATA DISPLAY MODE" appears. (The number could be "7" or "8", but this number is dependent on the type of tractor.) Then, scroll to "CID 676" (left track steering lever position sensor) and to "CID 677" (right track steering lever position sensor).