MOUNT-ENGINE 1403592 - Caterpillar

Table 1
Event Type    
Code     Type     Color    
A     Alarm     Red    
N     Notice     Yellow    
L     Log     Green    
Table 2
UPS Status    
Code     Status    
A     AVR    
B     Bypass    
D     Discharge    
NC     No Change    
S     Shutdown    
O     Online    Note: The UPS will remain online as long as there are enough functioning flywheels to support the load. Therefore, any notice or alarm from a flywheel may not result in a UPS state change.If the UPS status is not online or discharge, the load will not be protected during a utility outage. If the "UPS Status" is "AVR" or "Bypass", the load will be powered but not protected from a utility outage If the UPS status is "Shutdown", the load will not have power for a certain amount of time regardless o the utility source.
Table 3
!!ERROR!! DEADLINE TIMEOUT!!     A     A     The main control board has been reset from a "frozen" state.    
!!ERROR!! Memory Access Timeout!!     A     A     The main control board has detected a memory access problem.    
Low 24V Supply Detected.     N     A     The main control board has detected a loss of 24 vdc control power.    
Resetting the APC Board     L, A     A     The main control board has been reset.    
+15V APC1 PS Failure:     A     A     The main control board has detected a 15 vdc power supply failure.    
"<userName> Logged In", Engr/Mfg authorized for 30 minutes.     L     NC     A password has been accepted.    
"<userName> Logged In", "Field Service" authorized for 30 minutes.     L     NC     A service level password has been accepted.    
-15V APC1 PS Failure:     A     A     The main control board has detected a 15 vdc power supply failure.    
190V PS has failed.     A     A     The main control board has detected a loss of control power.    
Accepted service mode password, authorized for 30 minutes     L     NC     A valid password has been accepted.    
CAN Node Offline.     N     A     The indicated node on the CAN network has failed for report.    
CAN Node Online.     L     NC     The indicated node on the CAN network has returned to the network.    
cannot enter calibration, FWA at 100 RPM     L     NC     Certain calibrations cannot be performed while the flywheel is spinning.    
Code update: abort requested     L     A     A user command was entered to abort the firmware update.    
Code update: failed, device could not be programmed     A     A     Firmware has failed to be loaded, check communication connection and setpoints.    
Code update: failed, not in programming mode     N     A     Firmware not set to receive program upload.    
Code update: failed, timed-out waiting for