MOUNT 2363962 - Caterpillar

Illustration 1 g02563076
Illustration 2 g02563017
Bolt Tightening sequence
Table 1
Specification for 219-0627 Flywheel Housing Gp
Item Qty Part Specification Description
During assembly, inspect the following components for any foreign materials: The front face of the flywheel housing, the two sides of the flywheel housing gasket and the rear face of the cylinder block. These components must be free of the following substances: oil, fuel, water, gasket adhesive, assembly compounds, and any other foreign material.
Apply a small amount of 1U-8846 Gasket Sealant in order to fill the space between the cylinder block, the flywheel housing, and the oil pan before installing the oil pan gasket and the oil pan. The components must be assembled within 20 minutes of applying the gasket sealant.
Use the following procedure to tighten the flywheel housing bolts:
1 8 8D-0648 Bolt 1. Tighten bolt (1) through bolt (9) in a numerical sequence as shown in Illustration 2 to 100 20 N m (74 15 lb ft) .
2. Tighten bolt (10) through bolt (22) in a numerical sequence as shown in Illustration 2 to 40 10 N m (30 7 lb ft). Bolt (14) and bolt (15) are located behind the idler gear.
3. Again, tighten bolt (1) through bolt (9) in a numerical sequence as shown in Illustration 2 to 135 20 N m (100 15 lb ft).
4. Again, tighten bolt (10) through bolt (22) in a numerical sequence as shown in Illustration 2 to 55 10 N m (41 7 lb ft).
2 1 5J-5793 Bolt
3 6 165-3930 Bolt
4 4 165-3932 Bolt
5 3 223-4903 Bolt