MOUNT 2486816 - Caterpillar

Personal injury or death can result if two persons are not used in the following procedure.
Personal injury or death can result from a parking brake malfunction. Do not operate the machine if the parking brake does not function correctly.Be sure the parking brake components are adjusted correctly before attempting to return the machine to service.
Personal injury or death can result from sudden machine movement.Sudden movement of the machine can cause injury to persons on or near the machine.Prevent possible injury by performing the procedure that follows before working on the machine.
Table 1
Required Tools    
Tools     Part Number     Description     Qty    
C     198-4240     Digital Pressure Indicator Gp     1    Machine Preparation
Park the machine on a smooth level surface.
Place the transmission control in the NEUTRAL position.
Lower the bowl to the ground.
Engage the parking brake.
Shut off the engine.
Place blocks in front of the wheels and behind the wheels.
Allow only authorized personnel on the machine. Keep unauthorized personnel off the machine and in clear sight of the operator.
Disengage the parking brake.Testing and Adjusting Procedure
Illustration 1 g01666394
View of the parking brake that is located on the rear of the tractor (A) Disengaged dimension for the parking brake. (1) Starwheel. (2) Access hole. (3) Brake drum. (4) Lever. (5) Splined shaft. (6) Bolt holes for the brake drum.
Remove eight bolts (6) that hold brake drum (3) on to the drive shaft yoke. This allows rotation of brake drum (3) for correct adjustment.
Access starwheel (1) through access holes (2). Rotate starwheel (1) until the brake shoes press against the brake drum. The brake shoes must cause enough drag so that the drum (3) cannot be rotated by hand. Then rotate starwheel (1) in the opposite direction by 12 clicks.
Push up on lever (4). Dimension (A) is measured from the centerline of lever (4) to the bottom mounting hole of the bracket assembly for parking brake actuator. Dimension (A) equals 56 15 mm (2.2 .6 inches).Note: In order to adjust lever (4), remove lever (4) from the splined shaft (5). Rotate lever (4) about splined shaft (5) in order to achieve dimension (A) .
Install eight bolts (6) that hold brake drum (3) on to the drive shaft yoke.
Illustration 2 g01667355
Parking brake in the ENGAGEDRight Side View of the Parking Brake (B) Engaged dimension for parking brake. (4) Lever. (7) Actuator. (8) Nut. (9) Rod. (10) Yoke. (11) Cotter. (12) Clevis pin.
Without applying pressure to actuator (7), adjust rod (9) to equal dimension (B). Dimension (B) equals 95.0 mm (3.74 inch).
Illustration 3 g01646454
The parking brake is in the DISENGAGED position.
Remove the dust cover and connect tooling (C) to the test port.
Start the engine. Operate the engine until actuator (7) is fully pressurized. At this pressure, rod (9) fully extends.Note: The parking brake should be in the DISENGAGED position for the next step.
Make a final adjustment of the length of rod (9). To adjust, push up on lever (4) so that the cam for the parking brake contacts