MOUNT AS 3054339 - Caterpillar

Table 1
Manufacturing Effectivity For New Software    
Sales Model     Electronics Gp - Implement     Software P/N     Mfg Effectivity    
980GII     175-4206-03     246-6582     S/N:AWH01698    
972GII     180-0586-03     246-6580     S/N:ANY00357    
966GII     209-7818-03     246-6574     S/N:ANT00234    
962GII     210-0341-02     246-6571     S/N:AXS00372    
950GII     196-8890-02     246-6514     S/N:AXR00282    Implement System Software Enhancement List
A. - Support for the 2-axis joystick control with soft detents was added (no magnetic detents). After hardware is installed the joystick must be configured through the Electronic Technician configuration screen Joystick Installation Status and must be set to "Installed". Then the key switch must be cycled OFF then ON for the change to take effect. The lever position sensor calibrations must then be performed.B. - A dump kickout feature can now be enabled through the Electronic Technician configuration screen when the joystick is installed (without requiring additional hardware). This function returns the bucket to a level position from a tilted back racked back position. This feature is useful for clean-up operations, side-dump buckets and other needs to level the bucket after tilting it back. C. - When configuration parameters need to be programmed, CID/FMI 268-02 is displayed. The two parameters that may require programming are Lift Linkage Configuration and Work Tool Configuration. On the active diagnostic screen, the parameters that need to be programmed are listed below the diagnostic code. The parameters on the configuration screen will have the value "Not Programmed" until changed to the correct setting.D. - When changing the Start of Modulation Currents through the Electronic Technician configuration screen, or when the ECM has been replaced, the "out of calibration" fault on the related solenoid will be cleared. Since the currents are being changed manually, there is no need to force a recalibration of those components.E. - Improvements were made to Movement Without Command (E349, E350) and Movement in Wrong Direction (E351, E352) event triggers to reduce the possibility that they will be logged incorrectly.F. - Disabled the Movement Without Command (E349, E350) and Movement in Wrong Direction (E351, E352) events while in the Implement Hydraulic Service Mode. This will allow a service technician to swap the raise and lower functions or swap the lift and tilt functions for troubleshooting purposes, and not log these events, which would shut down the hydraulics.G. - The display of Hydraulic Oil Temperature in the Hydraulic Service Mode has been changed to display the correct temperature.H. - Linkage position sensor diagnostics have been improved by changing the diagnostic debounce time on the linkage sensors from 0.2 seconds to 0.4 seconds.I. - The configuration of the 3rd function has been enhanced. If the "3rd Function Enable Status" is enabled or the "Switched Auxiliary Function" is installed, then Electronic Technician will update other parameters so that only the key switch needs to be cycled before performing the 3rd function lever and valve calibrations. Previously, in order to change either of the parameters,