MOUNT 3367168 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g00596538Note: Drain engine oil into a suitable container for disposal.
Remove bolts (1) and the washers that hold engine oil pan (2) to the cylinder block.
Remove engine oil pan (2) and the gasket. Use a rubber mallet to tap lightly on engine oil pan (2) if it is necessary. Note: Do not pry on the engine oil pan.Installation Procedure
Clean the mating surfaces of the engine oil pan and the cylinder block. Note: Do not put liquid gasket material on the oil pan gasket or on the gasket surface of the engine oil pan.
Put the gasket and the engine oil pan (2) in position on the cylinder block. Install bolts (1) and washers.
Illustration 2 g00596576
Typical drawing (6 cylinder engine)
Tighten four bolts (3). Start with bolt (4) and tighten the remaining bolts in a counterclockwise sequence.
Tighten bolts to a torque of 31 3 N m (23 2 lb ft).
Fill the crankcase with engine oil to the proper level. Refer to Operation and Maintenance Manual, "Refill Capacities".