MOUNT 4373580 - Caterpillar

Refer to Table 1 for the software minimum requirements that are needed for AccuGrade components. If version 11.21 of the AccuGrade software is used with system components that have older versions of software, the "Diagnostics" screen will be displayed. The "Diagnostics" screen will show the correct version of software that is required.Refer to the applicable Systems OperationTroubleshootingTesting and Adjusting, "Display Firmware Upgrade" for detailed information about upgrading the firmware for the system.Note: If the software for the radio is not the required version level, the radio will be listed as "Not Found". The "Diagnostics" screen will continue to prompt the operator.Upgrading
Illustration 1 g02175194
Check the software support option expiration date on the CD700. If the date is 16November 2009, or later, the display can be upgraded. If the date is before 16November 2009, a new service support key is required before upgrading the display. A new service support key is part of the AccuGrade v11.21 upgrade kit that must be purchased from Trimble Navigation Ltd at http://heavyandhighwaypartners.trimble.com. If necessary, select "Create an Account" in the right-hand dialogue.The software can be downloaded from the "Downloads" section of SISweb. Refer to Illustration 1. This download is a self-extracting zip file that contains all the current production software for AccuGrade 3D v11.21 on the following machine types: Motor Graders, Track-Type Tractors, Excavators, Wheel Tractor Scrapers and Compactors.Once the software is extracted, the software is broken up into the following folders:
Display- Contains the display firmware (*.SG2)
Radio- Contains the Radio folders that have instructions and firmware in order to update the radio. A radio service cable and MCGFlash are required in order to flash TC series radios.
Sensors- Contains two subfolders, which are Cat Electronic Technician (Cat ET) Flashable and Display Flashable. The AccuGrade components for the excavator system must be upgraded via the display. Some of the AccuGrade components can be flashed with Cat ET and will use a (*.fls) file type. The display can be used to upgrade most AccuGrade components by entering the "Upgrade Software" menu on the display.
Valve Module- Contains firmware for valve modules. There is an operating system upgrade and a new (*.sg2) file when upgrading to v11.21. Refer to the following steps to complete the setup:
The pre-update (*.mch) and (*.dsp) files are automatically restored to the display, however, save the files to the compact flash card before upgrading.
Put the files from the display folder (eboot.bin, fpga_cmb.bin, nk.bin, AccuGrade_1121.SG2) on the root folder of the card.
Turn off power to the machine.
Install the card in the display and then repower the machine.
Press the display power button and you will be prompted to update. Follow the on-screen instructions to complete the update.Additional service literature for AccuGrade v11.21 is available from Trimble Navigation Ltd at http://heavyandhighwaypartners.trimble.com. If necessary, select "Create an Account" in the right-hand dialogue.