MOUNT 5088197 - Caterpillar

and procedures may result in diminished performance of the product and/or accelerated wear of components.Use mileage, fuel consumption, service hours, or calendar time, WHICH EVER OCCURS FIRST, in order to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance.Note: Before each consecutive interval is performed, all maintenance from the previous interval must be performed.When Required
Battery - Recycle
Battery - Replace
Battery or Battery Cable - Disconnect
Engine - Clean
Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
Engine Storage Procedure - Check
Fuel System - Prime
Fuel Tank Water and Sediment - Drain
Radiator - Clean
Daily
Air Tank Moisture and Sediment - Drain
Coolant Level - Check
Driven Equipment - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Power Take-Off Clutch - Check
Walk-Around Inspection
Every 250 Service Hours
Engine Oil Sample - Obtain
Grounding Stud - Inspect/Clean/Tighten
Hoses and Clamps - Inspect/Replace
Initial 500 Service Hours
Engine Valve Lash - Check
Every 500 Service Hours
Battery Electrolyte Level - Check
Engine Oil and Filter - Change
Fuel System Primary Filter (Water Separator) Element - Replace
Hoses and Clamps - Inspect/Replace
Every 500 Service Hours or 3 Months
Air Shutoff - Test
Belts - Inspect/Adjust/Replace
Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Fuel System Secondary Filter - Replace
Every 2000 Service Hours or 1 Year
Coolant Sample (Level 2) - Obtain
Fumes Disposal Filter Element - Replace
Every 2500 Service Hours
Engine Valve Lash - Check
Every 3000 Service Hours or 3 Years
Coolant (DEAC) - Change
Coolant Temperature Regulator - Replace
Every 4000 Service Hours
Air Compressor - Check
Engine Mounts - Inspect
Every 4000 Service Hours or 2 Years
Crankshaft Vibration Damper - Inspect
Starting Motor - Inspect
Every 5000 Service Hours
ARD Spark Plug - Replace
Diesel Particulate Filter - Clean/Replace
Fuel Priming Pump - Replace
Every 6000 Service Hours or 3 Years
Coolant Extender (ELC) - Add
Every 12 000 Service Hours or 6 Years
Coolant (ELC) - Change
PM Level 2 - Every 83 250 L (22 000 US gal) of Fuel or 2000 Service Hours or 1 Year
Aftercooler Core - Clean/Test
Every 208 000 L (55 000 US gal) of Fuel or 5000 Service Hours
Turbocharger - Inspect
Water Pump - Inspect
Every 340 000 L (90 000 US gal) of Fuel or 10 000 Service Hours
Overhaul Considerations
Speed Sensor - Clean/Inspect
Every 340 500 L (90 000 US gal) of Fuel or 10 000 Service Hours
Overhaul Considerations