MOUNT-RUBBER 6T6080 - Caterpillar

Illustration 1 g01261192 (1) Torque for two studs ... 30 4 N m (22 3 lb ft) (2) Torque for four bolts ... 30 4 N m (22 3 lb ft)
Illustration 2 g01593758 (3) Torque for the regulator ... 17 2 N m (13 1 lb ft) (4) Torque for two socket setscrews ... 15 2 N m (11 1 lb ft) (5) Torque for three bolts that hold the retainer shaft ... 7.0 0.4 N m (60 4 lb in)Use the following procedure to tighten the bolt (6) :
Apply 154-9731 Thread Lock Compound to the threads of the bolt.
Tighten the bolt to 200 N m (150 lb ft).
Back out the bolt for 180 degrees.
Again, tighten the bolt to 200 N m (150 lb ft).
Rotate the bolt to an angle of 31 2 degrees.
Illustration 3 g01593814 (A) Installation depth for the dowel ... 5.0 1.0 mm (0.20 0.04 inch) (C) Orientation of the regulator to 10 0.5 degrees
Illustration 4 g01630719
View B-B
(D) Orientation of the elbow to 30 degrees (7) Torque for the elbow ... 37 4 N m (27 3 lb ft) (8) Torque for the O-ring connector ... 22 2 N m (16 1 lb ft) (9) Torque for two bolts ... 30 4 N m (22 3 lb ft) (10) Torque for two studs ... 30 4 N m (22 3 lb ft)
Illustration 5 g01632977 (11) Torque for the stop plug ... 4.5 0.5 N m (40 4 lb in)