MOUNT AS 8N1214 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 5P-3931 Anti-Seize Compound -
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g02432376
Loosen the nuts on turbine clamp (11) enough to allow turbine housing (12) to rotate.
Loosen the nuts on compressor clamp (10) enough to allow compressor housing (9) to rotate.
Illustration 2 g02430976
Apply Tooling (A) on the exhaust manifold studs. Note: Discard the locknuts after use. Use new locknuts for installation.
Attach a suitable lifting device on turbocharger (7). The weight of turbocharger (7) is approximately 42 kg (93 lb).
Install the gasket and turbocharger (7) on the exhaust manifold. Install locknuts (8). Do not tighten the locknuts at this time.
Illustration 3 g02430916
Install the exhaust piping on the turbocharger. Position the turbine housing with the exhaust pipe in order to prevent binding.
If necessary, c