MOUNT, DEFLECT 9N7025 - Caterpillar

Cut all cable straps (51) that secure harness assembly (52) for the fire suppression system to the transmission, the torque converter, and the output transfer gears.
Illustration 26 g03666294
Disconnect harness assemblies (53). Disconnect clamp (54) from the machine frame.
Disconnect hose assembly (55).
Illustration 27 g03665865
Attach Tooling (B) and a suitable lifting device to transmission (56). The combined weight of the torque converter, transmission (56), and the output transfer gears is approximately 1510 kg (3330 lb).
Illustration 28 g03666234
Right side of the machine.
Illustration 29 g03666242
Left side of the machine.
Attach Tooling (C) to each side of flywheel housing (57).
Illustration 30 g03666266
Remove bolts (58) and the washers.
Illustration 31 g03666281
Left side of the machine.
Remove nut (59), the washers, and the bolt. Repeat this step for the opposite side of the machine.
Illustration 32 g03665865
Illustration 33 g03666933
Illustration 34 g03666935
Use Tooling (B) and the suitable lifting device in order to raise the torque converter, transmission (56), and the output transfer gears approximately 102 mm (4.0 inch).
Run the adjusting screws down on Tooling (C) until the adjusting screws make solid contact with the frame.
Illustration 35 g03666379
Remove bolts (60), the washers, and the bosses except for the five bolts (60), the washers, and the bosses at the bottom.
Illustration 36 g03666424
Lower the transmission, the torque converter, and the output transfer gears slightly. Remove the remaining bolts (60), the washers, and the bosses.
Illustration 37 g03666884
Raise the transmission, the torque converter, and the output transfer gears until support assembly (62) is visible, as shown in Illustration 37. Attach a suitable lifting device to support assembly (62). The weight of support assembly (62) is approximately 55 kg (121 lb). Remove bolts (61), the washers, and the spacers. Use the suitable lifting device in order to remove support assembly (62). Repeat this step for the opposite side of the machine.
Illustration 38 g03666918
Use Tooling (B) and the suitable lifting device in order to remove the torque converter, transmission (56), and the output transfer gears. Installation Procedure
Install the torque converter, transmission (56), and the output transfer gears in the reverse order of removal.
Tighten bolts (61) to a torque of 520 70 N m (384 52 lb ft).
Apply Tooling (D) to the threads of bolt (44).
Tighten bolt (44) to a torque of 475 60 N m (350 44 lb ft).