MOUNT AS 9R5391 - Caterpillar

Personal injury can result from the sudden release of high pressure oil.Be sure the engine has been shut off for a minimum of five minutes to be sure that the accumulator pressure is zero.The accumulator is filled with dry nitrogen. Do not loosen or remove the valve or cap from the top of the accumulator. A bleed screw at the bottom of the accumulator can be used to release the pressure that is left in the system.
Note: Put identification on all lines, on all hoses and on all wires for installation purposes. Plug all lines and all hoses. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Apply the parking brake.
Illustration 1 g00277573
Raise the lift arms off the ground by approximately 1.5 m (5 ft). Place Tooling (A) under the lift arms, as shown.
Release the pressure in the hydraulic system. Refer to Disassembly and Assembly, "Hydraulic System Pressure - Release".
Illustration 2 g00984591
Remove nuts (1) and cover (2) .
Illustration 3 g00984587
Disconnect hose assembly (3) .
Disconnect fitting (4) .
Remove tee (5) .
Illustration 4 g00984588
Remove bolts (6). (The rear clamp is shown.)
Carefully remove ride control accumulator (7) .Installation Procedure
Table 2
Required Tools    
Tool    Part Number    Part Description    Qty    
A     8S-7630     Stand     2    
8S-7631 Tube     2    
8S-7615 Pin     2    
8S-8048 Saddle     2    
Personal injury or death can result from improper accumulator charging.Dry nitrogen is the only gas approved for use in the accumulator. Charging the accumulator with oxygen gas will cause an explosion. This danger will not happen if nitrogen cylinders with standard CGA Compressed Gas Association, Inc.Number 580 connections are used.When ordering nitrogen gas, be sure that the cylinders are equipped with CGA Number 580 Connections. Do not use color codes or other methods of identification to tell the difference between nitrogen and oxygen cylinders.Never use an adapter to connect your nitrogen charging group to a valve outlet used on both nitrogen, oxygen or other gas cylinders. Be sure you use dry nitrogen (99.8 % purity).
Illustration 5 g00984588
Position ride control accumulator (7) and install bolts (6) .
Illustration 6 g00984587
Install tee (5) .
Connect fitting (4) .
Connect hose (3) .
Illustration 7 g00984591
Position cover (2) and install bolts (1) .
Fill the hydraulic system with oil. Refer to Operation and Maintenance Manual, "Lubricant Viscositites" and Operation and Maintenance Manual, "Capacities (Refill)".
Illustration 8 g00277573
Raise the lift arms and remove Tooling (A) .
Release the parking brake.End By: Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".