MOUNTING GP-ENGINE 1427279 - Caterpillar

Illustration 8 g01421673
Remove retaining ring (15) and washer (16). Remove pin (17) .
Remove tilt cylinder (11) .
Repeat Step 7 through Step 11 for the remaining tilt cylinder.Disassembly and Assembly Information
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
D     1P-0510     Driver Gp     1    
E     4C-4032     Bearing Mount Compound     1    
Cylinders equipped with lock valves can remain pressurized for very long periods of time, even with the hoses removed.Failure to relieve pressure before removing a lock valve or disassembling a cylinder can result in personal injury or death.Ensure all pressure is relieved before removing a lock valve or disassembling a cylinder.
Illustration 9 g01421876
(1) Before assembly, lubricate the threads with clean grease. Torque for the head ... 600 130 N m (442 95 lb ft)Tooling (D) is used for the removal and installation of bearing (2) . (3) Before assembly, apply Tooling (E) to the wiper seal groove. (4) Before assembly, lubricate the sealing lip with the fluid that is being sealed.Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 10 g01421890
Use a suitable lifting device in order to install tilt cylinder (11). The weight of tilt cylinder (11) is approximately 54 kg (120 lb).
Illustration 11 g01421673
Install pin (17). Install washer (16) and retaining ring (15) .
Illustration 12 g01421672
Install pin (14). Install washer (13) and retaining ring (12) .
Illustration 13 g01421566
Connect hose assembly (10). Install clamps (9) .
Repeat Step 1 through Step 4 for the remaining tilt cylinder.
Illustration 14 g01421565
Install cylinder brace (8). Install clamps (7) .
Illustration 15 g01421583
Install magnet (6). Install bolts (5) .
Illustration 16 g01421581
Install control group (4). Install clamps (3) .
Illustration 17 g01421580
Connect harness assembly (2). Install cable straps (1) .