MOUNTING GP-TRANSMISSION 2246938 - Caterpillar

Removal Procedure
Contact with high pressure fuel may cause fluid penetration and burn hazards. High pressure fuel spray may cause a fire hazard. Failure to follow these inspection, maintenance and service instructions may cause personal injury or death.
Contact with high pressure fuel may cause personal injury or death. Wait 60 seconds after the engine has stopped to allow fuel pressure to purge before any service or repair is performed on the engine fuel lines.
Note: Cleanliness is an important factor. Before you begin the removal procedure, the exterior of the components should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Turn the fuel shutoff valve to the OFF position.
Illustration 1 g02825218
Place a suitable container below fuel pressure regulator (1) in order to catch any fuel that might be spilled.
Disconnect tube assembly (2) from fuel pressure regulator (1) .
Remove fuel pressure regulator (1) from the fuel manifold.Installation Procedure
Illustration 2 g02825221
Install fuel pressure regulator (1) to the fuel manifold.
Connect tube assembly (2) to fuel pressure regulator (1). Tighten tube assembly (2) to a torque of 30 N m (22 lb ft).
Turn the fuel shutoff valve to the ON position.
Prime the fuel system. Refer to Operation and Maintenance Manual, "Fuel System - Prime".