MOUNTING GP-ENGINE 2922953 - Caterpillar

Improper lubrication can cause damage to machine components.To avoid damage, make sure that the proper amount of grease is applied to the swing drive.When the amount of grease in the compartment becomes too large, the agitation loss becomes large, thereby accelerating grease deterioration.Grease deterioration can cause damage to the pinion gear of the swing drive and swing internal gear. Not enough grease will result in poor gear lubrication.
Note: Refer to Operation and Maintenance Manual, "Lubricant Viscosities" for more information on the types of grease to use.
Illustration 1 g00834990Remove the inspection cover that is located at the base of the upper structure. Inspect the grease.
Illustration 2 g00834993
(1) Bolts
(2) Washers
(3) Cover
(4) Gasket
Remove bolts (1) and washers (2). Remove cover (3) and gasket (4).
Illustration 3 g00688058
(3) Cover
(4) Gasket
Inspect gasket (4). Replace the gasket if there is damage.
Check the level of the grease. The grease should be evenly distributed on the floor of the pan. Refer to Operation and Maintenance Manual, "Capacities (Refill)" for the size of the pan.Add grease, as needed. Remove grease, as needed. Too much grease will result in the deterioration of the grease because of excessive movement of the grease. Too little grease will result in poor lubrication of the swing gear.
Illustration 4 g00688063
(5) Bolts
(6) Washers
(7) Cover
(8) Gasket
Check for contamination and for discolored grease.
If the grease is contaminated or discolored with water, change the grease. Remove bolts (5), washers (6), cover (7), and gasket (8) in order to allow the water to drain. When you reinstall cover (7), inspect gasket (8). Replace the gasket if there is damage.
Illustration 5 g01133184
Raise the work tool and turn the upper structure by 1/4 turn. Lower the work tool to the ground.
Repeat Step 3 through Step 6 at every 1/4 turn in four places. Add grease, as needed.
Install gasket (4), cover (3), washers (2), and bolts (1).