MUFFLER 0017424 - Caterpillar

Illustration 1 g01329465
To access the calibration procedures for the Machine ECM, establish the connections of the Cat ET to the Machine ECM. Navigate to the calibration screen by clicking "Service" on the tool bar and then clicking "Calibrations". Click on the calibration that is needed.Once the specific calibration is selected, the Cat ET will guide you through the calibration procedure.The Cat ET will list initial machine conditions that must be satisfied before the ECM will allow the calibration procedure to continue. Follow the specific instructions on the display in order to successfully complete the calibration procedure.Note: If, at any time any of the calibrations are aborted by either the operator or the ECM the "CALIBRATION REQUIRED" diagnostic will be active and the ECM will revert to the previous successful calibrated values. In order to clear the diagnostic, key cycle the machine. The following list details the calibrations that can be performed for the components on the Machine ECM."Implement Valve Solenoid Calibrations (Pressure - Based)"
Personal injury can result from hot oil spray.Make sure all attachments have been lowered, oil is cool and the pressure has been released from the hydraulic system before removing any components or lines.Be sure there is no pressure in the tubing before it is disconnected from the fitting.Do not allow hot oil or components to contact skin.
This calibration requires a tool in order to calibrate the initiation current for each implement circuit. The tool is a pressure sensor that is connected to the outlet pressure port for the implement pump. The test checks the amperage that is required in order to produce pressure that is above the stand by pressure in the implement system. The test determines the initiation current that is needed in order to start the actuation of each of the individual circuits in the machine software.
Blade Raise Solenoid
Blade Lower Solenoid
Blade Tilt Right Solenoid
Blade Tilt Left Solenoid
Blade Angle Right Solenoid
Blade Angle Left Solenoid
Auxiliary Valve #1 Port A Solenoid
Auxiliary Valve #1 Port B SolenoidRequired Tools
Illustration 2 g01436814
Tooling (A)
Table 1
Required Tools    
Tool    Item    Part Number    Description    Qty    
A     A1     221-3405     Pressure Sensor Gp     1    
A2 301-7445     Coupler     1    
A3 3J-1907     O-Ring Seal     1    Note: If special tool (A) cannot be fabricated or is not available, the implement solenoid calibration can be performed by using "visual" cylinder movement confirmation. See the below "Implement Valve Solenoid Calibrations (Visual)".Calibration Procedure
Illustration 3 g01323955
(S/N: NCF1-62FBH1-1254DHA1-1558) (1) Pump discharge pressure tap
Illustration 4 g02624977
(S/N: NCF63-UPFBH1255-UPDHA1559-UP) (1) Pump discharge pressure tap
With the key switch "OFF", connect the coupler of special tool (A) onto the implement test port (1). Install the connector of special tool (A) into the 3-pin harness connector that is located next to the remote test panel.
Connect Cat ET and turn the key switch "ON".Note: The option for "Implement Valve Solenoid Calibrations (Pressure- Based)" will only appear if tool (A) is properly connected before turning on Cat ET.
Follow the steps in Cat ET. All of