MUFFLER AS 1198411 - Caterpillar

1198411 MUFFLER AS Caterpillar parts 928G, IT28G

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA1198411
119-8411
1198411

Weight: 25 pounds 11 kg.

Information:

BODY DIAMETER/WIDTH 209.6 mm

BODY LENGTH 612.6 mm

INLET ID 89.3 mm

OUTLET OD 92.13 mm

OVAL HEIGHT 292.1 mm

OVERALL LENGTH 0 mm

PROTECTIVE SHIELD N

WITH EJECTOR N

WITH MOUNTING BRACKET Y

WITH OUTER WRAP N

Buy MUFFLER AS 1198411 Caterpillar genuine, new aftermarket tractor parts with delivery
INTEGRATED TOOLCARRIER, WHEEL LOADER,

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

CTP 1198411 Muffler Assembly for Model 925G

$162.93

04 Jun 2024

Amazon.com

CTP 1198411 Muffler Assembly for Model 925G
CTP For model 925G || Sold in each || Easy in-and-out fit

$164.95

21 May 2024

Amazon.com

CTP 1198411 Muffler Assembly for Model 925G
CTP For model 925G || Sold in each || Easy in-and-out fit

$163.13

17 Apr 2024

Amazon.com

CTP 1198411 Muffler Assembly for Model 925G
CTP For model 925G || Sold in each || Easy in-and-out fit

Show more prices Caterpillar parts

This part in 2 request: Show. This information for suppliers only!

#735987 1198411

2021-10-08

#7124 1198411

2016-06-16

Number on catalog scheme: 1

Caterpillar 1198411 Parts scheme MUFFLER AS

For full view, you need register

Compatible equipment models: 1198411:

INTEGRATED TOOLCARRIER IT28G

WHEEL LOADER 928G Caterpillar

Information:

Remove Flywheel Housing
start by: a) remove flywheel 1. Remove oil from engine and remove covers (3) from each side of oil pan.2. Remove the bolts (1) that hold oil pan to flywheel housing. Loosen the remainder of oil pan bolts (2) and let oil pan hang down from cylinder block. 3. Remove covers (4) and (5) from flywheel housing. 4. Remove baffle (6) and bolts that hold flywheel housing to timing gear housing.5. Install two 1/2"-13NC forged eyebolts and fasten a hoist as shown. 6. Remove flywheel housing (7) from engine. Weight of flywheel housing is 325 lb. (147 kg).Install Flywheel Housing
1. Install flywheel housing (1) and bolts that hold it to timing gear housing. Cut off bottom ends of housing gasket even with lower surface of cylinder block. 2. Turn oil seal ring in thrower (2) until opening in ring is toward top of engine. Install baffle (3). 3. Install covers (4) and (5) on flywheel housing.4. Install and tighten all oil pan bolts. If oil pan gasket was destroyed during disassembly, it must be replaced with a new one. 5. Install covers (6) on each side of oil pan. Fill engine with oil.end by: a) install flywheel