MUFFLER AS 1703308 - Caterpillar

Calibrator Output
Connect the 8T-5197 Calibrator Cable and Adapter to the audio jack on the back of the Multi-Tool DIM.
Illustration 146 g03372984
DIM Audio Jack Location
Illustration 147 g03373003
Calibrator Output Basic Steps
Use the LEFT and RIGHT Direction keys to adjust the frequency resolution in increments of 1, 10, 100, and 1000 Hz.
Use the On / Off function key (F1) to start and stop the signal output.
Use the UP and DOWN Direction keys to select the desired output frequency.Service Parts
Use the CAT Media Logistics System to order Software License Cards and use the CAT Parts Distributions System to order all other parts.
Illustration 148 g03373020
Table 83
Item     Part No     Description    
1     285-0908     Multi-Tool    
2     285-0905     Internal Battery Power Pack    
3     285-0907     Diagnostic Interface Module (DIM)    
4     285-0896     5 Pin DIN Adapter    
5     285-0906     Universal AC/DC Power Supply with Four International Power Cords    
6     285-0904     Battery DC Power Cable Assembly    
7     285-0903     Blowby Cable Assembly with Ground Clip    
8     285-0902     Accessory Case (tools in photo not included)    
9     202-8643     Accessory Case, 514.4 x 212.7 x 225.4 mm (20 1/4 x 8 3/4 x 8 7/8 in)    
10     NETG5044     Blowby/Airflow Indicator Software License Card    
11     NETG5045     Signal Generator Software License Card    
12     NETG5046     Electronic Position Indicator Software License Card    
13     NETG5047     Engine Timing Indicator Software License Card    
14     NETG5049     Multitach 2 Software License Card    
15     NETG5051     Digital Thermometer Software License Card    
16     NETG5053     Fuel Flow Monitor Software License Card    
17     381-8114     USB Flash Drive    
18     386-5908     CF Memory    Note: Software License Cards are not required for 368-9910 Multi-Tool Phase 3, or Multi-Tools upgraded using 386-5908 Compact Flash Memory.Manufacturers Limited Warranty
THIS WARRANTY IS EXPRESSLY LIMITED TO ORIGINAL RETAIL BUYERS OF THE MANUFACTURER'S ELECTRONIC DIAGNOSTIC TOOLS ("UNITS").The Manufacturers Units are warranted against defects in materials and workmanship for three years (36 months) from date of delivery. Cables are warranted against defects in materials and workmanship for 90 days (3 months) from date of delivery. This warranty does not cover any Unit that has been abused, altered, used for a purpose other than that for which it was intended, or used in a manner inconsistent with instructions regarding use. The sole and exclusive remedy for any Unit found to be defective is repair or replacement, at the option of the Manufacturer. In no event shall the Manufacturer be liable for any direct, indirect, special, incidental or consequential damages (including lost profit) whether based on warranty, contract, tort or any other legal theory. The existence of a defect shall be determined by the Manufacturer in accordance with procedures established by the Manufacturer. No one is authorized to make any statement or representation altering the terms of this warranty.Disclaimer
THE ABOVE WARRANTY IS IN LIEU OF ANY OTHER