MULTIMETER GP- 2122160 - Caterpillar

Illustration 18 g01319864
Disconnect hose assemblies (48), (49), and (50) .
Illustration 19 g01319869
Remove bolts (53), the plate, and the clamps.
Reposition hose assemblies (54) out of the way.
Remove bracket assembly (51) .
Disconnect hose assembly (52) .
Illustration 20 g01320175
Disconnect clip (55) and remove bracket assembly (56) .
Remove tube assembly (57) .
Disconnect tee fitting (58) .
Illustration 21 g01320183
Remove tube assembly (59) .
Remove bracket assemblies (60) .
Attach Tooling (C), Tooling (B), and a suitable lifting device to torque converter, transmission, and output transfer gears (61). The weight of torque converter, transmission, and output transfer gears (61) is approximately 1135 kg (2500 lb).
Illustration 22 g01320225
Remove bolts (62) and use two people in order to remove guard (63). The weight of guard (63) is approximately 29 kg (65 lb).
Remove bolts (64) and use two people in order to remove guard (65). The weight of guard (65) is approximately 39 kg (85 lb).
Repeat Steps 50 and 51 for the opposite side of the machine.
Illustration 23 g01320218
Remove bolt (66) and the washer. Remove pin assembly (67) .
Reposition steering cylinder (68) .
Repeat Steps 53 and 54 for the opposite side of the machine.
Illustration 24 g01320250
Remove bolts (69) and straps (70). Reposition center drive shaft (71) .Note: Discard bolts (69) after bolts (69) have been removed.
Illustration 25 g01320550
Remove bolt (72), the washer, and the O-ring seal. Remove yoke (73) .Note: Note the orientation of yoke (73) for assembly purposes.
Illustration 26 g01320267
Remove bolt (74) and the washer.
Repeat Step 58 for the opposite side of the machine.
Illustration 27 g01320265
Use Tooling (C), Tooling (B), and the suitable lifting device in order to slightly raise the torque converter, transmission, and output transfer gears. Position suitable cribbing under flywheel housing (75) on each side of the machine.
Illustration 28 g01320322
Disconnect tube assemblies (76) and remove bolts (77) from flywheel housing (75) while the lifting tension is still on the torque converter, transmission, and output transfer gears.
Illustration 29 g01320352
Remove bolts (78) in order to remove mount assembly (79) .
Repeat Step 62 for the opposite side of the machine.
Illustration 30 g01320347
Use Tooling (B) in order to remove torque converter, transmission, and output transfer gears (61) from the machine.