NEEDLE 5363874 - Caterpillar

Accessing Active Diagnostic Codes
Illustration 1 g00859671
Typical ET screen for active diagnostic codesAfter the item "Implement Control D11" is selected, the item "Diagnostics" is selected from the drop-down menu. Then, select the "Active Diag. Codes" function. After the active diagnostic codes have been viewed, see the corresponding test procedure in this service manual.Accessing Inactive Diagnostic Codes
Diagnostic codes that are inactive or logged cannot be viewed by using the ET. The diagnostic codes that are inactive must be viewed by using the VIDS. However, the ET must be used in order to clear the inactive diagnostic codes.Clearing An Inactive Diagnostic Code
Note: The following action will clear the diagnostic codes in the VIDS. Inactive diagnostic codes for the implement ECM do not appear on any ET screen. These diagnostic codes only appear on the message center of the VIDS. However, this procedure is the only method that is used to clear the diagnostic codes from the implement ECM.Select the VIDS. Then, select the item "Diagnostics" from the drop-down menu. Then, select the "Logged Diag. Codes" function. Click on the "Include all ECM" button. Again, select "Diagnostics" and then select "Reset VIDS Event List". A diagnostic code that is active can not be cleared. Note: The use of the ET is the only method that is used to clear diagnostic codes that are logged in the implement ECM. This differs from the usual manner of using the ET. The VIDS manages the events of the implement ECM. The implement ECM does not keep the event list.Accessing Parameter Status
After selecting "Implement Control D11", select the "Information" item from the drop-down menu. Then, select the "Status" function. A list of groups will appear. From the list, select the desired group. The present status for the parameters of the selected group will now appear.Accessing Calibration
See the topic Testing and Adjusting, "Calibration".Accessing The Configuration
See the topic Testing and Adjusting, "Configuration".Parameters Of The Electronic Technician
Table 1
Parameters Of The Electronic Technician For The Implement Electronic Control Module    
"Implement Control D11 Group 1":
Position Of The Blade Control Lift Lever
Duty Cycle Of The Blade Control Lift Position Sensor
Percentage Of Current To The Blade Raise Solenoid
Percentage Of Current To The Blade Lower Solenoid
Status Of The Implement Lockout Solenoid
Oil Pressure Of The Main Hydraulic Pump
Position Of The Implement Lockout Switch
Extension Of The Left Lift Cylinder
Extension Of The Right Lift Cylinder
Pressure Of The Engine Cooling Fan Pump    
"Implement Control D11 Group 2":
Position Of The Blade Control Tilt Lever
Duty Cycle Of The Blade Control Tilt Lever
Percentage Of Current To The Tilt Left Solenoid
Percentage Of Current To The Tilt Right Solenoid
Position Of The Blade Tilt
Blade Tilt Mode
Status Of The Blade Tilt Limit
Status Of The Implement Lockout Solenoid
Oil Pressure Of The Tilt Hydraulic Pump
Pressure Of The Engine Cooling Fan Pump    
"Implement Control D11 Group 3":
Percentage Of Current For The Tilt Right Solenoid
Percentage Of Current For The Tilt Left Solenoid
Position Of The Pitch Forward Trigger Switch
Status Of The Pitch Regenerate Solenoid
Blade Pitch
Oil Pressure Of The Tilt Hydraulic Pump
Position Of The Pitch Forward Switch
Position Of