NOZZLE AS-FUEL VALVE 1043377 - Caterpillar

Illustration 1 g00403944
Illustration 2 g00403946
Illustration 3 g00403945
(1) Diameter of the output shaft (PTO) (A) ... 60.245 0.025 mm (2.3720 .0010 inch)The end play of the output shaft (1) ... 0.97 0.43 mm (.038 .017 inch) (2) The bearing in the carrier assembly should be installed to the following depth (B). ... 1.6 0.5 mm (.06 .02 inch) (3) When the engine is viewed from the rear, the split in the bearings should be located at the seven o'clock position. (4) Inside diameter of the drive gear for the power take-off ... 60.320 0.025 mm (2.3750 .0010 inch)The clearance between the output shaft (1) and the drive gear (4) for the power take-off ... .025 to .125 mm (.0010 to .0050 inch) (5) When the engine is viewed from the rear, the split in the bearings should be located at the seven o'clock position. (6) Thickness of the thrust washer ... 4.690 0.025 mm (.1850 .0010 inch) (7) Thickness of the thrust washer ... 4.690 0.025 mm (.1850 .0010 inch) (8) Thickness of the thrust plate ... 6.75 mm (.266 inch) (9) The bearing must not extend beyond either face of the idler gear assembly. Relief (12) in the bearing must line up with the reliefs in the gear within 2 degrees. (10) Depth of the seal ... 2.5 0.5 mm (.01 .02 inch)