NOZZLE A. 4M9973 - Caterpillar

Removal Procedure
Start By:
Remove the bottom guard. Refer to Disassembly and Assembly, "Bottom Guard (Engine) - Remove and Install".Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Illustration 1 g01183075
Open access panel (1) and hood (2) .
Illustration 2 g01183077
Remove panel (3) .
Illustration 3 g01183078
Illustration 4 g01183080
Remove guards (4) and (5). Remove hose (6). Disconnect hose (8) and elbow (10). Remove panels (7) and (9) .
Illustration 5 g01182425
Disconnect harness assembly (11) and cable assembly (12). Remove bolt (13) from the bracket. Remove ground strap (16), mounting bolts (14), and electric starting motor (15) .Installation Procedure
Illustration 6 g01182425
Position electric starting motor (15). Install mounting bolts (14) and ground strap (16). Install bolt (13) to the bracket. Connect cable assembly (12) and harness assembly (11) .
Illustration 7 g01183080
Illustration 8 g01183078
Install panels (7) and (9). Connect hose (8) and elbow (10). Install guards (4) and (5). Install hose (6) .
Illustration 9 g01183077
Install panel (3) .
Illustration 10 g01183075
Close hood (2) and close access panel (1) .End By: Install the bottom guard. Refer to Disassembly and Assembly, "Bottom Guard (Engine) - Remove and Install".