AVSPARE.COM
parts catalog

NUT 0543464 - Caterpillar



0543464 NUT Caterpillar parts NUT
Rating:
36
Alternative (cross code) number:
CA0543464
054-3464
0543464
Caterpillar 0543464 NUT
Weight: 0.40 pounds 0 kg.

Buy NUT 0543464 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Illustration 58 g01886826
Install bearings (24) and (26) in gear (25).
Position thrust discs (23) and (27) on each side of the gear (25).
Put gears (25) in position in the carrier. Install planetary shafts (21). Make sure that the holes in planetary shafts (21) are in alignment with the holes in the carrier. Install spring pin (22). Make sure that spring pins (22) are flush with the counterbore in the carrier.
Repeat Steps 73 through 75 for the installation of the remaining gears.
Illustration 59 g01886819
Put slinger (20) in position in the carrier. Install locks (18) and bolts (19) that hold the slinger (20) in position. Bend the tabs on locks (18).
Illustration 60 g06327038
Put carrier assembly (17) in position on the shaft assembly. Install the spacer on the carrier. Use Tooling (E) to install retaining ring (16) on the shaft assembly.
Illustration 61 g06327035
Install gear (15) on the carrier assembly.
Illustration 62 g01886815
Install dowels (14) in the manifold assembly.
Start with a friction disc and install friction discs (12) and clutch plates (13).
Illustration 63 g01886814
Install seals (10) on the piston. Apply clean transmission oil to seals (10).
Install piston (11) in piston housing (9).
Illustration 64 g02505510
Illustration 65 g01886812
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Install springs (8). Use Tooling (D) to hold the piston in the housing. Attach Tooling (B) and a suitable lifting device to the housing. The weight of clutch housing (9) is approximately 32 kg (70 lb).
Install clutch housing (9). Install bolts (7) that secure the planetary group. Tighten bolts (7) to a torque of 115 7 N m (85 5 lb ft)
Illustration 66 g02505542
Attach Tooling (B) and a suitable lifting device to planetary group (5). The weight of planetary group (5) is approximately 565 kg (1250 lb). Install planetary group (5) into transmission case (6).
Illustration 67 g01915279
Install tubes (4) and the O-ring seals.
Illustration 68 g01915255
Install Tooling (B) and a suitable lifting device to modulating valve assembly (2). The weight of modulating valve assembly (2) is approximately 43 kg (95 lb).
Install bolts (3).
Illustration 69 g01915234
Connect tube assembly (1).
Illustration 70 g01915213
Remove the transmission assembly from Tooling (A).End By:
Connect the transmission and the output transfer gears.


Parts nut Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.