NUT 0964879 - Caterpillar

Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g00555701
Loosen the nuts on V-band clamps (2) enough to allow compressor housing (1) and turbine housing (4) to rotate.
Illustration 2 g00612892
Use 5P-3931 Anti-Seize Compound on the manifold bolts.
Position gasket (5) and turbine housing (4) on the exhaust manifold. Install the manifold bolts. Do not tighten bolts completely.
Tighten the nut on V-band clamp (2) for turbine housing (4) to a torque of 14 3 N m (10 2 lb ft).
Tighten manifold bolts (5) to a torque of 55 5 N m (41 4 lb ft).
Position compressor housing (1) so the air outlet is zero degrees from top vertical.
Tighten the nut on V-band clamp (2) for compressor housing (1) to a torque of 14 3 N m (10 2 lb ft).
Lightly tap around the diameter of both V-band clamps (2) with a soft hammer. Tighten the nuts on both V-band clamps (2) to a torque of 14 3 N m (10 2 lb ft).
Illustration 3 g00612952
Install the seals and tube assemblies (6) and (7) .