NUT 1B1333 - Caterpillar

A beeper alerts the operator of an approaching avoidance zone. Caterpillar strongly recommends that you use a harness that has a beeper, and that you do not turn the beeper off.
Setting the Beeper
The CAESbasic system includes a beeper. The beeper provides an audible signal when the soft keys are pressed and when the system warning alarms are activated. An example of a system warning alarm is the avoidance zone entry warning alarm.Perform the following steps in order to access the "Beeper" dialog.
CAESbasic must be in Configuration mode in order to access the beeper setup. From the "Setup Menu - Configuration" dialog, press the down arrow key or the up arrow key until "Beeper" is highlighted.
Illustration 1 g01024752
Press the "OK" key. The "Beeper" dialog appears. This is shown in illustration 1.
Press the down arrow key or the up arrow key in order to select "On" or "Off".If you select "On", the beeper signal will be audible.If you select "Off", the beeper signal will not be audible
Do one of the following.
Press the "OK" key in order to confirm the setting. The beeper setup is saved. The "Beeper" dialog is closed and the "Setup Menu -Configuration" dialog appears. The changes take effect immediately.
Press the "ESC" key and then press the "OK" key in order to return to the "Setup Menu -Configuration" dialog without saving the changes.
Press the "ESC" key in order to exit the "Setup Menu - Configuration" dialog.