NUT 1B4210 - Caterpillar

Illustration 1 g00526768
(S/N: 86G3000-3187)
Illustration 2 g00286357
(S/N: 86G3188-UP)
Raise the bucket and dump the bucket. Move the tilt control lever to TILT BACK detent position.
Illustration 3 g00526768
(S/N: 86G3000-3187)
Illustration 4 g00286357
(S/N: 86G3188-UP)
When the present bucket angle is reached, the control lever returns to HOLD position. Lower the bucket and check the cutting angle.
Illustration 5 g00521194
Position the bucket on the ground.Single Lever Control
Illustration 6 g00520937
(S/N: 86G3000-3187)
Illustration 7 g00336959
(S/N: 86G3188-UP)
Raise the bucket (1) and dump the bucket (4). Move the single lever control to TILT BACK detent position (3) .
When the present bucket angle is reached, the single lever control returns to HOLD position. Lower the bucket and check the cutting angle.
Position the bucket on the ground.Adjust:
Illustration 8 g00521232
Loosen bolts (1) in order to adjust the bucket positioner. Vertically center bucket positioner switch assembly (2) over magnet (3) .
Illustration 9 g00521282
Dimension (A) from the switch to the magnet should be between 8 mm (0.31 inch) and 12 mm (0.47 inch).
Illustration 10 g00521286
Tighten screw (4) in order to adjust dimension (A) .
Tighten bolts (1) in order to secure this position.