NUT-FULL-STRAPS & BRACKETS 3S2713 - Caterpillar

Illustration 1 g01447548Note: Use 5P-3931 Anti-Seize Compound on the bolt threads.The tightening sequence for the cylinder head bolts follows:
In a numerical sequence, tighten bolts 1 through 26. Torque for bolts ... 270 15 N m (199 11 lb ft)
In a numerical sequence, tighten bolts 1 through 26. Torque for bolts ... 450 15 N m (332 11 lb ft)
In a numerical sequence, again tighten bolts 1 through 26. Torque for bolts ... 450 15 N m (332 11 lb ft)
In a numerical sequence, tighten nuts 27 through 39. Torque for nuts ... 45 7 N m (33 5 lb ft) (40) Tighten the exhaust manifold studs that are in each cylinder head to the following torque. ... 35 5 N m (26 4 lb ft)
Illustration 2 g01447549 (A) Height of new cylinder head ... 112.78 .25 mm (4.440 0.010 inch)
Illustration 3 g01447551Note: Use 6V-6640 RTV Silicone Sealant on the plugs. (B) The plugs are installed into the cylinder head at the following depth. ... 4.5 0.5 mm (0.18 0.02 inch) (C) The plugs are installed into the cylinder head at the following depth. ... 2.0 0.5 mm (0.08 0.02 inch)
Illustration 4 g01447552Note: Use 5P-3931 Anti-Seize Compound on the bolt threads. (41) Tighten the sleeve to the following torque. ... 100 10 N m (74 7 lb ft)