NUT 5S1770 - Caterpillar

Use this procedure to troubleshoot the electrical system if one of the diagnostic codes in Table 1 is active.
Table 1
Diagnostic Codes Table
J1939 Code and Description CDL Code and Description Conditions which Generate this Code System Response Procedure
630-2Calibration Memory : Erratic, Intermittent, or Incorrect 268-2
Programmed Parameter Fault : Erratic, Intermittent, or Incorrect The Electronic Control Module (ECM) detects that one or more of the programmable parameters have not been programmed. The engine performance may be affected by unprogrammed parameters. The unprogrammed parameters determine the action that is taken by the ECM. The ECM may use a default torque map or the ECM may limit the engine to low idle. Program the missing parameter. System configuration parameters are parameters that affect emissions and power of the engine. Default values for the parameters are programmed at the factory. Some parameters may be changed by the customer in order to suit the needs of the specific application. Values for these parameters can be viewed on Caterpillar Electronic Technician (ET). Certain configuration parameters are also stamped on the engine information plate.No password is required for programming a new ECM during the first 100 hours of service life. This 100 hour “free configuration” feature enables the customer to tailor the programmable setpoints to the requirements of the installation. Exceptions are "Fuel Limit" and "Personality Module Mismatch".Note: If the parameters that are protected with the factory passwords are changed, the Caterpillar warranty may be voided.If a programmable parameter has not been programmed, the ECM will generate a 268-2 diagnostic code. The unprogrammed parameters will be set to default. Certain aspects of the engine performance and engine monitoring may be affected.If an injector code has not been programmed, the ECM will generate a 1495-2 diagnostic code. The injector code is a number that is found on each of the unit injectors. The ECM uses this number to compensate for manufacturing variations between individual injectors. If you replace any of the unit injectors, reprogram the code for the new injectors. Also, if you replace the ECM, reprogram all of the injector codes.Note: The injector codes are not part of the "Configuration" screen on the electronic service tool. "Injector Codes Calibration" can be found under "Calibrations" in the "Service" menu on Cat ET.Parameter Table
Table 2
System Configuration Parameters
Parameter Default Range Password
Required
"Personality Module Interlock" Yes
"ECM Serial Number" Yes
"Engine Serial Number" 00000000 8 alphanumeric numbers No
"Equipment ID" 00000000000000000 17 alphanumeric numbers No
"Full Load Setting (FLS)" 0 -128 to +127 Yes
"Full Torque Setting (FTS)" 0 -128 to +127 Yes
"Fuel Ratio Control Offset (FRC)" 0 −25 to 0 No
"Rated Fuel Positon (mm)" 14 The minimum rack is based on engine power. Yes
"Fuel Correction Factor (%)" 0 -25 to +25 No
"Low Idle (rpm)" 1000 810 to 1000 No
"Governor Gain Factor" Engine rating 0 to 39,999 Yes
"Governor Minimum Stability Factor" Engine rating 0 to 39,999 Yes
"Governor Maximum Stability Factor" Engine rating 0 to 39,999 Yes
"Acceleration Rate (rpm/sec)" 250 5 to 2000 No
"Programmable Torque Scaling" The minimum rack is based on engine