NUT 9H5402 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of maintenance, including all adjustments, the use of proper lubricants, fluids, and filters. The user is also responsible for the replacement of components due to normal wear and aging. Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components. Use fuel consumption, service hours, or calendar time, WHICH EVER OCCURS FIRST, to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance. Before each consecutive interval is performed, all maintenance from the previous interval must be performed.When Required
Battery - Recycle
Battery - Replace
Battery or Battery Cable - Disconnect
Circuit Breakers - Reset
Coolant Extender (ELC) - Add
Engine - Clean
Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
Ether Starting Aid Cylinder - Replace
Fuel System - Prime
Generator - Dry
Generator Set - Test
Generator Set Alignment - Check
Daily
Coolant Level - Check
Electrical Connections - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Generator Load - Check
Jacket Water Heater - Check
Power Factor - Check
Voltage and Frequency - Check
Walk-Around Inspection
Initial 20 to 40 Service Hours
Belts - Inspect/Adjust/Replace
Every Week
Engine Oil Level - Check
Generator - Inspect
Generator Bearing Temperature - Test/Record
Generator Lead (Flat Braided Cable) - Check
Initial 250 Service Hours
Engine Valve Rotators - Inspect
Every 250 Service Hours
Coolant Sample (Level 1) - Obtain
Every 250 Service Hours or 6 Months
Battery Electrolyte Level - Check
Engine Oil Sample - Obtain
Fuel Tank Water and Sediment - Drain
Hoses and Clamps - Inspect/Replace
Every 500 Service Hours or 1 Year
Belts - Inspect/Adjust/Replace
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Oil and Filter - Change
Engine Protective Devices - Check
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Every 2000 Service Hours or 1 Year
Engine Crankcase Breather - Clean
Generator Lead (Round Cable) - Check
Generator Set Vibration - Inspect
Radiator - Clean
Stator Lead - Check
Every Year
Coolant Sample (Level 2) - Obtain
Rotating Rectifier - Check
Every 3000 Service Hours or 3 Years
Alternator - Inspect
Coolant Temperature Regulator - Replace
Crankshaft Vibration Damper - Inspect
Electronic Unit Injector - Check/Replace
Engine Mounts - Inspect
Engine Valve Lash - Check
Engine Valve Rotators - Inspect