NUT-FULL 9S8216 - Caterpillar

Any adjustment to the governor must be made only by a person approved by Caterpillar or by a Caterpillar Dealer.(1) Torque for nut ... 12 4 N m (9 3 lb.ft.)(2) Rack stop spring. See MISCELLANEOUS SPRING CHART. (3) Piston assembly.(4) Cushion spring for piston assembly. See MISCELLANEOUS SPRING CHART. (5) Governor spring. See GOVERNOR SPRING CHART. (6) Diameter of the outer surface of the cylinder (new) ... 38.100 0.013 mm (1.5000 .0005 in.) Bore in the gear (new) ... 38.151 0.013 mm (1.5020 .0005 in.)(7) Put marks in alignment on pinion-stop and gear before installing dowel.(8) Bore in the bearing (after assembly) ... 22.263 0.038 mm (.8765 .0015 in.) Diameter of the gear, at the hub (new) ... 22.187 0.013 mm (.8735 .0005 in.)
PLATE ASSEMBLY(9) Distance from the face of the plate to the bearing for the governor drive assembly ... 0.51 0.25 mm (.020 .010 in.)(10) Dowel installation: Angle A must be ... 54 10° Dimension B must be ... 7.9 0.5 mm (.31 .02 in.) (11) Install dowels to get a dimension of ... 5.6 0.5 mm (.22 .02 in.)
CONTROL SHAFT BEARINGS(12) Bore in the governor control shaft bearings (after assembly) ... 15.761 0.038 mm (.6205 .0015 in.) Diameter of the governor control shaft (new) ... 15.720 0.008 mm (.6189 .0003 in.) (13) Distance between the bearings for the governor control shaft ... 60.58 0.13 mm (2.385 .005 in.) (14) Distance from the face of the housing to the end of the bearing for the governor control shaft ... 43.38 0.15 mm (1.708 .006 in.)
SHUTOFF SHAFT BEARINGS(15) Bore in the shutoff shaft bearing (new) ... 12.713 0.013 mm (.5005 .0005 in.) Diameter of the shutoff shaft (new) ... 12.637 0.013 mm (.4975 .0005 in.)(16) Distance from center of bolt hole to outside of sleeve bearing ... 90.25 0.50 mm (3.553 .020 in.) (17) Needle bearing.(18) Distance from center of bolt hole to outside end of needle bearing (17) ... 21.69 0.50 mm (.854 .020 in.)(19) Torque for insulator ... 4.5 0.6 N m (40 5 lb.in.)Install seals as shown.