O-RING 0944084 - Caterpillar

8S2328 Dial Indicator Group InstalledFace Runout (axial eccentricity) of the Flywheel Housing:
1. Fasten a dial indicator to the crankshaft flange so the anvil of the indicator will touch the face of the flywheel housing.2. Put a force on the crankshaft toward the rear before reading the indicator at each point.3. With dial indicator set at .000 in. (0.0 mm) at location (A), turn the crankshaft and read the indicator at locations (B), (C) and (D).4. The difference between lower and higher measurements taken all four points must not be more than .012 in. (0.30 mm), which is the maximum permissible face runout (axial eccentricity) of the flywheel housing.