OIL PUMP 6V2352 - Caterpillar

Table 1
Parts List    
Part Number     Quantity     Description    
142-1657     1     Bracket Assembly    
5K-9660     1     Clip    
3-9514     1     Coupling    
8C-6867     2     Connector    
147-3150     1     Bracket    
6V-9835     1     T-Fitting    
8T-4195     1     Bolt    
138-9936     1     Washer    
9G-9981     1     Breather    
123-6319     1     Non-Vented Fuel Tank Cap    
4J-5477     3     O-Ring    
8T-4133     1     Nut    
Illustration 1 g00945006
Install 8C-6867 Connector (3) onto the straight end of 138-9936 Hose Assembly (5). Use one 4J-5477 O-Ring Seal (4) between the hose assembly and the connector.
Assemble 3-9514 Coupling (2) to the 8C-6867 Connector (3) .
Install 9G-9981 Breather (1) onto the coupling.
Illustration 2 g00945058
Disconnect the 137-5590 Hose Assembly from the 6V-9000 Elbow that is located on the fuel tank.
Illustration 3 g00945070
Assemble 6V-9835 Tee (8) onto 6V-9000 Elbow. Use an 4J-5477 O-Ring Seal (9) between the elbow and the tee. Install the tee so that fuel in the breather hose (5) will drain back into the drain hose for the fuel (7) .
Assemble 137-5590 Hose Assembly (7) to the vertical end of the 6V-9835 Tee (8) .
Assemble the 138-9936 Hose Assembly (5) to the tee. Use one 4J-5477 O-Ring Seal (9) between the hose and the tee.
Illustration 4 g00945169
Illustration 5 g00945171
Mount the 142-1657 Bracket to the stud for the mounting bracket for the air conditioning that is located on the engine frame. Use one 8T-4121 Hard Washer and one 8T-4133 Nut .
Attach 147-3150 Angle (10) to 142-1657 Bracket (11) by using one 8T-4121 Hard Washer and one 8T-4133 Nut .
Place 5K-9660 Clip (6) around the crimped area of 138-9936 Hose Assembly. Attach the clip to the bracket, as shown.
Replace the existing fuel tank cap with a new 123-6319 Fuel Tank Cap Assembly .