OPERATOR AR-COLD WEATHER 1367826 - Caterpillar

At operating temperature, the engine coolant is hot and under pressure.Steam can cause personal injury.Check the coolant level only after the engine has been stopped and the fill cap is cool enough to touch with your bare hand.Remove the fill cap slowly to relieve pressure.Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
When a Caterpillar Extended Life Coolant (ELC) is used, an Extender must be added to the cooling system. See the Cooling System Specifications in the Special Publication, SEBU6250 for all cooling system requirements.Use a 8T-5296 Coolant Test Kit to check the concentration of the coolant.For additional information about the addition of Extender, see the Special Publication, SEBU6250, "Cooling System Specifications" or consult your Caterpillar dealer.
Topping off or mixing Cat ELC with other products that do not meet Caterpillar EC-1 specifications reduces the effectiveness of the coolant and shortens coolant service life.Use only Caterpillar products or commercial products that have passed the Caterpillar EC-1 specification for pre-mixed or concentrate coolants. Use only Extender with Cat ELC.Failure to follow these recommendations can result in shortened cooling system component life.
Stop the engine. Allow the cooling system to completely cool.
Open the engine compartment.
Illustration 1 g01414144
Slowly loosen the cooling system pressure cap (2) in order to relieve system pressure. Remove the cooling system pressure cap (2).
Remove the cap for the expansion tank (1).
Add the recommended amount of extender to the coolant system. Refer to the Special Publication, SEBU6250, "Extended Life Coolant (ELC)" for the proper amount.
Illustration 2 g01414415
Maintain the coolant level between the "max" line (3) and the "min" line (4). Measure the level of the coolant when the machine is off and the cooling system has had sufficient cooling time.
If necessary, drain enough coolant from the radiator in order to allow the addition of the extender.
Start the engine. Run the engine without the radiator cap until the thermostat opens and the coolant level stabilizes.
Inspect the gasket on the cooling system pressure cap (2). Replace the cooling system pressure cap (2) if the gasket is damaged.
Install the cooling system pressure cap (2).
Install the cap for the expansion tank (1).
Close the engine compartment. For additional information on the addition of extender, see Special Publication, SEBU6250, "Coolant Recommendations" or consult your Caterpillar dealer.