OPERATOR AR 2295009 - Caterpillar

You must read and understand the warnings and instructions contained in the Safety section of this manual before performing any operation or maintenance procedures.Transmission
Change Filter
1. Use a strap-type wrench or a cross bar to remove the filter housing.2. Remove and discard the used element.3. Clean the filter housing with a clean, nonflammable solvent.4. Clean the housing base.5. Insert a new filter element into the filter housing.6. Inspect the filter housing seal. Replace the seal, if it is damaged.7. Install the filter housing into the housing base. 8. Start the engine. Apply the service brake. Use the right brake pedal only. 9. Slowly operate the transmission controls to circulate the transmission oil.10. Lock the transmission control lever in NEUTRAL. Inspect for leaks. 11. Maintain the oil level to the FULL mark on dipstick. Add the oil through fill tube if necessary.12. Stop the engine and install the access cover.Hydraulic System
Change Filter
1. Remove the oil filler cap slowly to relieve the tank pressure. 2. Loosen the retaining bolt (1).3. Remove the cover (2) and filter.4. Discard the filter element.5. Inspect the condition of the "O" ring seal. Replace if necessary.6. Install a new filter element and cover (2). Tighten the cover retaining bolt to 58 5 N m (40 4 ft lb). 7. Maintain the hydraulic oil to the FULL mark in sight gauge. Add oil if necessary through the fill tube.8. Inspect the filler cap gasket. Replace the gasket, if it is damaged. Install the oil filler cap.Drive Shaft Universal Joints
Lubricate Fittings
Wipe all fittings before lubricating. Lubricate one fitting in each of the two rear shaft universal joints.Total of two fittings.Fuel Tank Cap and Fill Screen
Clean
The fuel cap is located on the left side of the machine. 1. Remove the cap.2. Replace the cap if the gasket is damaged.3. Remove the strainer from the fill opening.4. Wash the strainer in clean, nonflammable solvent.5. Install the strainer.6. Install the tank cap.