OPTION AR-LINKAGE 3694251 - Caterpillar

Illustration 13 g01525016
(AA) Pin projection
Measure the pin projection with Tooling (K). Refer to Illustration 13 for the location of measurement.
Illustration 14 g02008397
Illustration 15 g02042314Note: Tooling (N) for swaging the track joints will require assembly. Refer to the above Illustration for assembly.
Install Tooling (N) onto Tooling (A).
Set the hydraulic pump to 0 kPa (0 psi).
Slowly extend the hydraulic cylinder until contact is made. Note: Verify that the track links are properly located on the track pin. If the track has already been swaged, the track link will need to be rotated 45 degrees from the previous swage.Note: After the pin boss has been swaged, all of the internal components of the track link assembly are pressed together with zero end play. If the components remain pressed together, the track link assembly will not articulate. Galling will occur on the thrust rings.
Position Tooling (L)