OPTION AR-HYDRAULIC 3966757 - Caterpillar

Face Runout (Axial Eccentricity) of the Flywheel
Table 1
Required Tools    
Part Number    Part Name    Qty    
8T-5096     Dial Indicator Gp     1    
Illustration 1 g00295955
Checking face runout of the flywheel
Refer to Illustration 1 and install the dial indicator. Always put a force on the crankshaft in the same direction before the dial indicator is read. This will remove any crankshaft end clearance.
Set the dial indicator to read 0.0 mm (0.00 inch).
Turn the flywheel at intervals of 25 mm (1.00 inch) along the outer circumference of the flywheel face, and record measurements at each point.
The difference between two consecutive measurements must not be more than 0.03 mm (0.001 inch), which is the maximum permissible flywheel face runout.Flywheel Runout
Note: The flywheel housing must be removed in order to perform this runout check.
Illustration 2 g00295956
Checking flywheel runout
Refer to Illustration 2 and install the dial indicator.
Set the dial indicator to read 0.00 mm (0.000 inch).
Turn the flywheel at intervals of 90 degrees and read the dial indicator.
Calculate the difference between the lowest measurement and the highest measurement of the four locations. This difference must not be greater than 0.50 mm (0.0197 inch). This dimension is the maximum permissible distance for the outside diameter runout of the flywheel.