OPTION AR-LINKAGE 3966779 - Caterpillar

Valve Calibration
In order to ensure proper performance of the hydraulic system on the machine, the valves must be calibrated.If this procedure was not completed during the initial installation of the AccuGrade system, refer to Testing and Adjusting, "Valve (Grade Control) - Calibrate".If the valve calibration has been completed, press the arrow keys in order to scroll to the next menu.Customize the AccuGrade System
The "Customize" menu is contained within the "Configuration" menu. This menu permits you to customize the AccuGrade system with the items in the following menus:Select the Operating Mode
Press the arrow keys until "Customize" is highlighted on the display.
Press the "OK" key in order to access the "Customize" menu. A screen that is similar to Illustration 4 appears.
Illustration 4 g01402897
Press the "OK" key in order to access the "Operating Mode" menu. A screen that is similar to Illustration 5 appears for the Dual Elevation System. A screen that is similar to Illustration 6 appears for the Single Elevation System.
Illustration 5 g01402942
Dual Mast System
Illustration 6 g01402943
Single Mast System
Press the arrow keys until the mode that is required is highlighted on the display.
Press the "OK" key in order to save the changes and exit back to the "Customize" menu.Note: In order to exit back to the "Customize" menu without saving any changes, press the "ESC" key.Set The Elevation Offset
The "Elevation Offset" menu allows the user to set the amount that the reference elevation will increase or decrease each time that the elevation offset switches are pressed. This allows you to move the blade a certain distance in the upward or downward direction with the toggle of a switch.
Press the arrow keys until "Offset" is highlighted on the display.
Press the "OK" key in order to access the "Offset" menu. A screen that is similar to Illustration 8 appears.
Illustration 7 g01299820
Press the arrow keys until "Elevation" is highlighted on the display. Press the "OK" key.A screen that is similar to Illustration 8 appears.
Illustration 8 g01299822
To edit the elevation offset increment, complete the following steps:
Press the menu key (6) in order to move the cursor to the right and highlight the digit.
Press the up arrow keys (1) in order to increase the highlighted value. Press the down arrow keys (1) in order to decrease the highlighted value.Note: Press "ESC" (7) and "OK" (8) simultaneously in order to reset the elevation offset to the default (0.030 m).
Press the "OK" key in order to save the changes and exit to the "Customize" menu.In order to exit back to the "Customize" menu without saving any changes, press the "ESC" key.
Press the menu key.A screen that is similar to Illustration 9 will be shown for the Dual Mast system.A screen that is similar to Illustration 10 will be shown for the Single Mast system.
Illustration 9 g01402993
Illustration 10 g01402954
Guidance screen for a Single Mast systemConfigure the Display for Single Elevation Operation
Illustration 11 g01403006
Press the arrow keys in order to