ORIFICE 0833949 - Caterpillar

Hydraulic Oil Temperature Indicator (34)
Hydraulic Oil Temperature Indicator - The indicator for the hydraulic oil temperature will illuminate when the hydraulic oil in the hydraulic tank is too hot. If the light for the hydraulic temperature illuminates, stop the machine. Move the throttle switch to low idle. Allow the machine to idle for a few minutes. Resume operating the machine if the temperature returns to the normal temperature. If the temperature remains above normal, stop the machine. Investigate the cause of the alarm. Do not operate the machine until the cause of the alarm has been repaired.Indicator for the Charging System (35)
Indicator for the Charging System - The indicator for the charging system will illuminate when the charging system is malfunctioning. If the indicator illuminates, stop the machine in a safe area. Investigate the cause of the problem. Check for a loose alternator belt or a broken alternator belt. Repair the problem before you use the machine. Neutral Indicator (36)
Neutral Indicator - The indicator will illuminate when the propel lever is in the NEUTRAL position. Adjustment for the Amplitude Setting with Handwheel (If Equipped)
Be sure the machine is stopped, the parking brake engaged, and the engine is shut off before you change the amplitude settings on the drums.Failure to do so could result in personal injury or death.
There are two separate wheels that are used in order to adjust the amplitude settings on the machine. The amplitude setting wheel for the front drum is located on the left side of the front drum. The amplitude setting wheel for the rear drum is located on the right side of the rear drum.The same adjustment procedure for the amplitude setting wheel is used for the front drum and the rear drum.Note: When you change the amplitude setting on the machine, adjust both the front wheel and the rear wheel to the same setting.
Illustration 10 g02686476
(37) Low amplitude (38) Medium Low amplitude (39) Medium amplitude (40) Medium High amplitude (41) High amplitude
Amplitude Symbol - The amplitude setting wheel has five positions.
In order to change the amplitude setting, pull the amplitude setting wheel outward.
In order to select the desired amplitude setting, rotate the amplitude setting wheel in the appropriate direction.
When you have reached the desired position, release the amplitude setting wheel. Be sure that the amplitude setting wheel has locked in position.Window Wiper/Washer Switch
Illustration 11 g02686496
Front window wipers (42) . Use this switch in order to activate the front window wipers.Rear window wipers (43) . Use this switch in order to activate the rear window wipers.Note: Push switch (42) or push switch (43) in order for the window washers to operate.Circulation fan (44) . The control for the circulation fan is used in order to recirculate the cab air. The control has four operating positions: OFF, LOW, MEDIUM and HIGH.Heating and Air Conditioning Control
Illustration 12 g02686499
Fan control switch (45) - This switch controls the speed of the blower fan motor.Heater control (46) - Turn the control knob counterclockwise for a cooler temperature. Turn the control