ORIFICE 4259923 - Caterpillar

Attach 130-5300 Clip (18) to boss (17) that is welded to the inside of the left rear cab mount. Use the existing bolt and the existing washer. Connect 12-pin receptacle (15) from the 273-0155 Control Harness As to 12-pin plug (16). 12-pin plug (16) is part of the vehicle harness that is located on the left side of the machine inside the cab mount.
Illustration 13 g01215969
Route the 273-0155 Control Harness As from the underside of the cab. Secure the harness to the bottom side of the platform with four 5P-9299 Clips , eight 8T-4122 Hard Washers , four 8T-4136 Bolts , and four 8T-4133 Nuts (19) .Note: If the cab has been removed, use the alternate harness routing that is described in Step 12.
Illustration 14 g01215989
If the cab has been removed, 273-0155 Control Harness As (21) can be routed along main vehicle harness (20). Secure the 273-0155 Control Harness As to the main vehicle harness with 9X-6772 Cable Straps . Refer to Illustration 14.
Illustration 15 g01216015
Route the 273-0155 Control Harness As and the 263-8948 Antenna As through the opening that allows the ground strap to penetrate the liner.
Illustration 16 g01216037
Illustration 17 g01216044
The grommet has been removed.
Locate grommet (22) that allows the cab harness to penetrate the cab floor. Open the grommet and remove the brackets in order to route the 273-0155 Control Harness As and the 263-8948 Antenna As through the cab floor.
Illustration 18 g01216049
Connect 12-pin plug (23) from the 273-0155 Control Harness As to Product Link radio (24). Secure 263-8948 Antenna As (25) to Product Link radio (24). Secure the 273-0155 Control Harness As and the 263-8948 Antenna As wires to existing wiring with cable straps.
Illustration 19 g01216067
Illustration 20 g01216081
Remove the cover from the electronics bay. Identify bosses (26) for mounting the Product Link ECM and connector (27) for the Product Link ECM.
Illustration 21 g01216100
Mount Product Link ECM (29) to the bosses with eight 8C-5607 Isolation Mounts , four 8C-5608 Spacers , four 8C-8451 Bolts , and four 9X-6165 Washers (30). Connect 270-6873 Power Harness As (28) to connector (27). Secure the harness to the existing wiring with cable straps, as shown. Replace the cover on the electronics bay.
Illustration 22 g01216121
Attach the 260-7652 Film to the left front metal post inside the cab. Position the film approximately 1200 mm (47 inch) above the cab floor.