OUTER RACE & ROLLER ASSEM. 9H3816 - Caterpillar

Removal Procedure
Start By:
Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".Note: Put identification marks on all wires for installation purposes.
Lower the bucket to the ground.
Illustration 1 g00445184
Remove screw (1) and three screws (3) .
Disconnect switch assembly (2) .
Remove cover (4) .
Illustration 2 g00445185
Remove three screws (5) and cover (6) .
Illustration 3 g00445187
Illustration 4 g00445188
Rear View
Remove bolts (7) and bolts (8) .
Remove the cover enough to disconnect cigar lighter (9) .
Remove cover (10) .
Illustration 5 g00445189
Disconnect electrical connectors (13) .
Remove bolts (11) and hydraulic electronic control (12) .
Illustration 6 g00445365
Remove two nuts (14), the washers, and electronic position control (15) .Installation Procedure
Illustration 7 g00445365
Note: The slot in the electronic position control must be aligned to the slot of the control assembly.
Install electronic position control (15) .
Apply 9S-3263 Thread Lock Compound to the threads of the threaded rods.
Install the washers and nuts (14). The torque for nuts (14) is 2.25 .25 N m (20 2 lb in).
Illustration 8 g00445189
Install hydraulic electronic control (12) and bolts (11) .
Connect electrical connectors (13) .
Illustration 9 g00445187
Illustration 10 g00445188
Install cover (10) .
Connect cigar lighter (9) .
Install bolts (8) and bolts (7) .
Illustration 11 g00445185
Install cover (6) and three screws (5) .
Illustration 12 g00445184
Install cover (4) .
Connect switch assembly (2) .
Install three screws (3) and screw (1). The torque for screw (1) is 6 1 N m (53 9 lb in).End By: Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".