PACKING 1J2148 - Caterpillar

Problems with the electronic control system are reported via these types of codes: SPN/FMI codes, diagnostic codes, and event codes.For information on SPN/FMI codes, refer to Troubleshooting, "Diagnostic Codes".For information on diagnostic codes, refer to Troubleshooting, "Diagnostic Codes".For information on event codes, refer to Troubleshooting, "Event Codes".Use Table 1 as a cross-reference between the various types of codes.Portions of this material are reprinted with permission from SAE J1939DA_201607© 2016 SAE International. SAE International is not responsible for any use or translation of this material, in whole or in part. Please contact SAE International to obtain a complete copy of SAE J1939DA_201607, the official definitive source of this standard.
Table 1
Cross Reference for Diagnostic Codes
SPN(1)/FMI Code Diagnostic Code
or
Event Code Description of Code
1074-05 1248-05 Retarder Solenoid current below normal
1074-06 1248-06 Retarder Solenoid current above normal
626-05 2417-05 Ether Injection Control Solenoid open/short to +batt
626-06 2417-06 Ether Injection Control Solenoid short to ground
678-03 41-03 8 Volt DC Supply short to +batt
678-04 41-04 8 Volt DC Supply short to ground
3509-03 262-03 5 Volt Sensor DC Power Supply short to +batt
3509-04 262-04 5 Volt Sensor DC Power Supply short to ground
100-03 100-03 Engine Oil Pressure open/short to +batt
100-04 100-04 Engine Oil Pressure short to ground
100-10 100-10 Engine Oil Pressure abnormal rate of change
102-03 1785-3 Boost Pressure Sensor short to +batt
102-04 1785-4 Boost Pressure Sensor short to ground
102-10 102-10 Boost Pressure Sensor abnormal rate of change
102-03 1785-03 Intake Manifold Pressure Sensor voltage above normal
102-04 1785-04 Intake Manifold Pressure Sensor voltage below normal
102-10 1785-10 Intake Manifold Pressure Sensor abnormal rate of change
108-03 274-03 Atmospheric Pressure open/short to +batt
108-04 274-04 Atmospheric Pressure short to ground
110-03 110-03 Engine Coolant Temperature open/short to +batt
110-04 110-04 Engine Coolant Temperature short to ground
91-13 91-13 Throttle Position calibration required
91-08 91-08 Throttle Position signal abnormal
190-08 190-08 Engine Speed signal abnormal
723-08 342-08 Secondary Engine Speed signal abnormal
190-15 E362 (1) Engine Overspeed Warning
190-00 E362 (3) Engine Overspeed Shutdown
94-03 94-03 Fuel Pressure open/short to +batt
94-04 94-04 Fuel Pressure short to ground
105-03 172-03 Intake Manifold Air Temp open/short to +batt
105-04 172-04 Intake Manifold Air Temp short to ground
164-02 164-02 Injector Actuation Pressure signal erratic
164-03 164-03 Injector Actuation Pressure voltage high
164-04 164-04 Injector Actuation Pressure voltage low
164-11 164-11 Injector Actuation Pressure system fault
637-13 261-13 Engine Timing calibration required
100-17 E360 (1) Low Engine Oil Pressure Warning
100-18 E360 (2) Low Engine Oil Pressure Derate
100-01 E360 (3) Low Engine Oil Pressure Shutdown
729-05 617-05 Air Inlet Heater Relay open/current below normal
729-06 617-06 Air Inlet Heater Relay grounded/current above norm
168-00 168-00 System Voltage high
168-01 168-01 System Voltage low
168-02 168-02 System Voltage intermittent/erratic
630-02 268-02 Check Programmable Parameters
639-09 296-09 J1939 Data Link communications
110-15 E361 (1) High Engine Coolant Temperature Warning
110-1