PAD-MOUNTING 2990353 - Caterpillar

Start By:
Remove the stick.
When you are using hydraulic cylinders and puller studs, always ensure that the rated capacity of the puller stud meets or exceeds the rated capacity of the hydraulic cylinder. If the puller stud does not meet or exceed the rated capacity of the hydraulic cylinder, a sudden failure of the puller stud could occur. The sudden failure of the puller stud could result in personal injury or death.
Note: For the removal of the sleeve bearings from the stick at the pin joint for the bucket control linkage, refer to Disassembly and Assembly, "Bucket Linkage Bearings and Seals - Remove".
Illustration 1 g06200546
Illustration 2 g06200547
Repeat steps 1 and 2 for opposite side.
Illustration 3 g06200551
Illustration 4 g06200552
Repeat steps 3 and 4 for opposite side.
Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
C 5P-0960 Grease Cartridge 1
D 1P-0520 Driver Gp 1 Note: Make sure that the bearing bores for the sleeve bearings are free of paint and grease prior to the installation of the sleeve bearings.Note: Make sure that the bearings are installed in the bore so that the identification numbers of the bearings are facing outward.
Illustration 5 g06200553
Use Tooling (D) to drive the sleeve bearing into the bearing bore to the depth of dimension (E) 9.5 0.8 mm (0.37 0.03 inch).
Illustration 6 g06200554
Repeat steps 1 and 2 for opposite side.
Illustration 7 g06200556
Use Tooling (D) to drive the sleeve bearing into the bearing bore to the depth of dimension (F) 9.5 0.8 mm (0.37 0.03 inch).
Illustration 8 g06200557
Repeat steps 3 and 4 for opposite side.
End By:
Install the stick.