PAINT-PRIMER 4795395 - Caterpillar

Pull adjustment knob (1) in order to release the air from the seat.
Remove boot (2).
Illustration 2 g00876043
Loosen the setscrew in adjustment knob (1) and remove adjustment knob (1). Remove nut (3) and lockwasher (3A). Remove plate (4) from air valve (8).
Remove shaft assemblies (5).
Illustration 3 g00871951
Remove cable strap (6) in order to disconnect harness assemblies (9) from upper housing assembly (7).
Illustration 4 g00871971
Lift upper housing assembly (7) and push air valve (8) away from upper housing assembly (7). Remove upper housing assembly (7).
Illustration 5 g00871994
Disconnect harness assemblies (9) and hose assembly (10) from air valve (8).
Illustration 6 g00872007
Illustration 7 g00897454
Raise scissor assembly (11) and install blocking in order to prevent scissor assembly (11) from falling.
Remove bolts (12) in order to remove shock absorber (13) from scissor assembly (11) and housing assembly (14).
Remove bearings (12B) from shock absorber (13). Note: Illustration 7 shows the location of lockwasher (12A), bearings (12B), washers (12C), nut (12D), and locknut (12E).
Repeat Steps 9 and 10 if the seat is equipped with a shock absorber on the opposite side.
Illustration 8 g00872020
Illustration 9 g00872029
Remove shaft (15) in order to remove toggle assembly (16) from scissor assembly (11).
Remove screw (17) in order to disconnect spring assembly (18) from housing assembly (14).
Illustration 10 g00872031
Remove shaft assemblies (19) in order to remove scissor assembly (11) from housing assembly (14) and tether straps (11A).
Illustration 11 g00872037
Remove shaft (20) in order to remove toggle assembly (21) from scissor assembly (11).
Illustration 12 g00872043
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Remove hose assembly (22) and bolt (23) in order to remove spring assembly (18) from scissor assembly (11).
Illustration 13 g00872046
Remove bolts (24) in order to remove compressor assembly (25) from scissor assembly (11).
Illustration 14 g00891451
Remove compressor assembly (25) from mount (26).