PAN-OIL 1011521 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     -     Threaded Rod
M 20 -
6 by 45 cm (2.5 by 18 inch)     2    
B     138-7575     Link Bracket     1    Start By:
Remove the counterbalance valve.Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Illustration 1 g01960141
Illustration 2 g01960142
Install Tooling (B) and a suitable lifting device into Location (X). The weight of travel motor (4) is approximately 129 kg (284 lb).
Disconnect hose assemblies (1) and (2) .
Remove bolts (3) that are called out in Illustration 1. Install Tooling (A) in place of bolts (3) .
Remove remaining bolts (3) .
Slide travel motor (4) onto Tooling (A) .
Illustration 3 g01960146
Position a suitable lifting device, as shown.
Remove travel motor (4) .
Illustration 4 g01960149
Remove coupling (5) .Installation Procedure
Install travel motor (4) in the reverse order of removal.